Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Find the drain-to-source voltage for the pH sensor circuit in Figure 8-59 when a pH of 5 is measured. Assume the rheostat is set to produce 4 V at the drain when a pH of 7 is measured.
What is the maximum output resistance that the source follower must have if the output voltage is to remain within + or - 20% of nominal value. If the MOSFET has kn = 16 mA/V^2, at what current ID must it be biased.
Design a diode voltage regulator to supply 1.5V to a 150-ohm load. Use two diodes specified to have a 0.7-V drop at a current of 10mA. The diodes are to be connected to a +5-V supply through a resistor R.
An AC sine wave is applied to the input of a full wave rectifier. The output of the full wave rectifier is then applied to a half wave rectifier.
Describe specific engineering and manufacturing process planned to be used in the development of lithium air battery. Potential defects and that cause deviations in the development process. How this process can be used to minimize the amount of waste..
ECE 534 Homework. For a converter shown in Fig 2, Vg = 50V, L= 5 mH, C = 20µF, R = 2?, D = 0.8, fsw = 200 kHz, Mosfet Rdson = 5m? and diode forward voltage drop Vd = 0.5V. Draw the equivalent circuit of the converter
An oxygen-nitrogen mixture consists of 30 kg of oxygen and 40 kg of nitrogen. This mixture is cooled to 84 K at 0.1 MPa pressure. Determine the mass of the oxygen in the liquid and gaseous phase.
If we connect the two diodes from Problem 6 in parallel, andforce (using a constant current source) 500μA through them, what will the voltage be across each diode, and what will thecurrent be in each diode
When can an effective permittivity be defined for an anisotropic dielectric material?
Calculate the electrical energy generated per hour per cubic metre of water if the hydraulic efficiency be 0.86 and electrical efficiency 0.92.
The greatest rate of change of flux will occur when the core is ¼ to 3⁄4 the way through. In this region, if changes from 0.5 x 10-4 Wb to 8 x 10-4Wb, what is the force carried by the plunger?
The deflection of a pressure sensing diaphragm under large deflection conditions is non-linear with respect to the pressure difference across the diaphragm.
A battery has a short-circuit current of 20 A and an open-circuit voltage of 12 V. If the battery is connected to an electric bulb of resistance 2 ohm, calculate the power dissipated by the bulb.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd