Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A) A point charge Q1 lies at the center of a spherical conducting shell of inner radius a and outer raduis b. find the charge density on the two surfaces of the conduting shell if it has a net chargeQ2
B) charge is distributed with densityρ=ρ0r/a where ρ0 is a constant in the cylidrical region r<a find D everywhere and plot Dr versus r.C) charge is distributed with unifrom densityρ0C/m^3 in the region a<r<2a in spherical coordinates find D everywhere and plot D, versus r.
A three-phase synchronous generator (Delta-connected) rated at 10KVA, 230 V, has a synchronous reactance of 1.2ohms per phase and an armature resistance of 0.5ohms per phase. (a) Draw the phasor diagram.
What will be the power factor when the resistor voltage is 9 V at an angle of 30 degrees, and the capacitor voltage is 3 V at an angle of - 60 degrees in a RC series circuit. Also, what will be the power factor when the inductor voltage is 9 V.
A silver-coated sphere of radius 5 cm carries a total charge of 12 nC uniformly distributedon its surface in free space. (a)Calculate |D| on the surface of the sphere and (b)external to the sphere
A circular loop of radius a is located in the y-z plane center at the origin in the presence of a uniform B field pointed in the +x direction. At t=0 the loop is rotated counter clockwise with radial frequency about the z-axis.
a) Compute and plot the magnitude of the DFT for f(t) using "fftshift", assuming a sampling rate of 8000 Hz and a duration of 0.5 second. b) Window the samples of f(t) using a hann window
For a chip area with area 2cm x 2cm in a 180nm logic technology, what is the approximate area of the same chip when ported to a 32nm logic technology.
A system is needed to measure flow, which continuously cycles between 20 and 30 gal/min with a period of 30 sec. The required output is a voltage varying from -2.5 to +2.5 V for the cycling flow range. The sensor to be used has a transfer function..
A signal is sampled every 1ms for 20ms, with the following actual values of the analogue voltage at successive sampling times. Plot the values of the voltage recorder by a 5 volt, 4 bit ADC assuming that the noise level is much lower
A 20-Hp, 240VDC, 4-pole Shunt motor operates at rated load and 1700rpm and an efficiency of 88%. It has armature resistance of 0.2Ω and field resistance of 240Ω. Find: a)Power input to the motor b)IFLA of the motor
A three-phase 5 hp, 208 V motor has an efficiency of 92%, and a power factor of 0.87 (lagging) when it runs at full power. Calculate the motor phase currents and line currents if the motor is wye connected, and delta connected.
Ib is 15uA in a circuit where an NPN transistor has an Av of 75 and VCE is 10 when Vcc is 25 and Beda DC is 75 and the Ic is 1.125mA, What would Rc be, assuming Ve=0
Why then do we even use JFETs as amplifiers What is it that make them attractive even though they are non-linear? How do we minimize the effect of their non-linearity
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd