Find the change in thickness of the clay that will occur if

Assignment Help Civil Engineering
Reference no: EM13542316

A 10 ft layer of normally consolidated saturated clay is found at depth of 20 ft beneath a formation of partially saturated sandy silt with unit weight of 115 lb/ft cubed. Void ratio of the clay is 1.5 and specific gravity is 2.6. Find the change in thickness of the clay that will occur if the load on the surface increases by 2 tons/ft squared? The clay rests on sounds unweathered rock. Coefficient of consolidation of the clay is 4 ft squared/month. How many months will it take to have the clay settle 3 inches?

Reference no: EM13542316

Questions Cloud

Find the pressure head just upstream of c and just down : A pipeline 900 ft long discharges freely at a point 200 ft lower than the water surface at intake. The pipe intake projects into the reservoir. The first 600 ft is of 10-in diameter, and the remaining 300 ft is of 6-in diameter. Find the rate of disc..
Find the rate of discharge of water at 60 degrees fahreneit : Three new cast iron pipes, having diameters of 24, 21 and 18 in respectively, each 450-ft long, are connected in series. The 24-in pipe leads from a reservoir (flush entrance), and the 18-in pipe discharges into the air at a point 15 ft lower than th..
What percentage is this loss reduced if the provision : Water leaves a turbine at 18.5 fps and enters a tailrace having an average velocity of 1.5 fps. What is the submerged discharge head loss? By what percentage is this loss reduced if the provision of a draft tube increases the discharge flow area to s..
Determine the energy dissipated in the jump : A hydraulic jump forms in a horizontal trapezoidal channel. The base width is 4m and the side slopes are 45o. The depths upstream and downstream of the jump are 1m and 3m.
Find the change in thickness of the clay that will occur if : A 10 ft layer of normally consolidated saturated clay is found at depth of 20 ft beneath a formation of partially saturated sandy silt with unit weight of 115 lb/ft cubed. Void ratio of the clay is 1.5 and specific gravity is 2.6.
Compute the maximum and minimum load : Consider a 2014-T6 aluminum alloy the S-N behavior. A cylindrical rod of diameter 13.2 mm fabricated from this alloy is subjected to repeated tension-compression loading along its axis. Compute
Determine the range of values of p for which equilibrium is : A 5-m wide rectangular open channel lined with rubble masonry (n=0.025) and laid on a slope of 0.0004. If the depth of flow is 3 m, what is the rate of discharge (m3/s)
The pavement currently exhibits low to medium and localized : The pavement structure consists of 160 mm of hot-mix asphalt (HMA), 150 mm of granular base and 450 mm of subbase placed over silty clay subgrade. The pavement is 20 years old and its current PCI is 50. The pavement currently exhibits low to medium a..
How long would the electric heater run that night in the : A passive solar house that is losing heat is outdoors at an average rate of 50,000 kJ/h is maintained at 22oC at all times during a winter night for 10h. the house is to be heated by 50 glass containers each containing 20 L of water this is heated to..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Describe the difference between population standard

describe the difference between population standard deviation and sample standard deviation. describe a scenario in

  What torque is the engine producing at the vehicle speed

A 3400-lb car is traveling in third gear (ratio 2.5 to 1) on a level road at its top speed of 130 mi/h. The air density is 0.00206 slugs/cuft. The car has frontal area of 19.8 sqft, a drag coefficient of 0.28, a wheel radius of 12.6 inches, a driv..

  Determine the smallest allowable value of p of the tape

Knowing that the coefficents of friction between the tape and the drums are us=.40 and uk=0.30 and that drum C is free to rotate, determine the smallest allowable value of P if slipping of the tape on drum B is not to occur.

  Determine the friction angle and shear strength

Normal load at failure was 93.8N with a maximum shear load of 38.7N. Find stresses on the failure plane, sketch a graph showing these on the shear stress and normal stress axes. Find the friction angle and shear strength.

  Find minimum speed at which train could pass over the tank

find teh minimum speed at which the train could pass over the tank and lift water up to teh full 4 m height. (hint: consider the locomotive to be stationary and neglecting all losses)

  Determine what is the rotors angular velocity one minute

The rotor of an electric generator is rotating at 200 when the motor is turned off. Due to frictional effects, the angular acceleration of the rotor after the motor is turned off is α=-0.01ω rad/s^2

  A piece of stone m5kg is attached to a string with length

a piece of stone m5kg is attached to a string with length r80 cm and is rotating in a vertical circular path with

  Two pieces of steel are held together with six bolts one

two pieces of steel are held together with six bolts. one end of the first piece of steel is welded to a beam and the

  What is the mach number of the flow around the aircraft

A jet aircraft flies at a speed of 600 mph at an altitude of 40,000 ft. The atmosphere is the standard atmosphere. (1) What is the air pressure outside the aircraft (2) What is the Mach number of the flow around the aircraft

  Find the average velocity and mass flowrate out of the elbow

If the weight flowrate into the elbow is 47 lbf/s, find the mass flowrate out of the elbow, the volume flowrate in and out of the elbow, and the average velocity in and out of the elbow.

  What is the difference in reservoir elevations for 20 cfs

The characteristics of the line are 5,000 ft of steel pipe (e = 0.00015 ft) which has an ellipsoidal cross section (flow area = 4 ft^2; wetted perimeter = 8 ft); three standard elbows (K = 0.9 per elbow); a globe valve (K = 10); and a re-entrant p..

  Rocket velocity as a function of time

(a) Use differentiation to find a general expression for the rocket's velocity as a function of time, (b) When is the velocity zero?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd