Find the change in capacity

Assignment Help Electrical Engineering
Reference no: EM131392601

A capacitive displacement sensor is used to measure rotating shaft wobble, as shown in given Figure. The capacity is 880 pF with no wobble. Find the change in capacity for a + 0.02 to -0.02-mm shaft wobble.

1203_Figure 9.jpg

Reference no: EM131392601

Questions Cloud

Rational consumer will choose the product : In choosing between two products, a rational consumer will choose the product that gives her the:
Controlling population growth : Discuss one supply and one demand side factor that determines the number of children a couple chooses to have. Based on your answer what type of programs do you think will be successful in controlling population growth.
What resistance change corresponds to given resolution : The pot is wound on a 3-cm-diameter form, 5 cm long, and the distance between wires in the pot is 0.25 mm. What is the resolution in work-piece motion? What resistance change corresponds to this resolution?
What resistance change corresponds to given resolution : The pot is wound on a 3-cm-diameter form, 5 cm long, and the distance between wires in the pot is 0.25 mm. What is the resolution in work-piece motion? What resistance change corresponds to this resolution?
Find the change in capacity : A capacitive displacement sensor is used to measure rotating shaft wobble, as shown in given Figure. The capacity is 880 pF with no wobble. Find the change in capacity for a + 0.02 to -0.02-mm shaft wobble.
Rational choice theory would predict : Jason is faced with two options: A BMW costing $40,000 gives him an additional 800 units of utility, and a laser printer costing $1,000 gives him an additional 25 units of utility. Rational choice theory would predict that he would choose:
Review the design of the segway and address the question : The ability to eliminate the danger without seriously impairing the usefulness of the product or making it unduly expensive
What is the maximum bridge offset voltage amplitude : Develop an ac bridge for given Problem. Use 880 pF for all the bridge capacitors, and assume a 10-V rms, 10-kHz excitation. What is the maximum bridge offset voltage amplitude?
Compute the dfa index before and after these changes : Suggest some potential cost-reducing modifications you could make to improve theproduct costed above. Compute the DFA index before and after these changes.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the speed of the sphere after the acceleration

The charge is release from rest and accelerate through a potential difference of 100000v. (a) Find the speed of the sphere after the acceleration. (b) if the sphere (which is already up to its max)is fired directly at a fixed (can't move) charge q..

  Determine the true output snr and computed output snr

Investigate the multiplication quantization error behavior of this filter for B = 5 bits. Determine the true output SNR, the computed output SNR, and the upper and lower bounds of the SNR. Plot the normalized histogram of the output error.

  Explain power factor correction

Power factor correction, Three parallel impedances in rectangular form as follows

  For how long can the capacitor sustain the light

A 1.1 mF capacitor has initial voltage of 12 V.The energy stored in the capacitor is used to light up a 0.7 KOhm lamp.Assuming that the lamp is completely dimmed when the current through it is less than 0.2 mA, for how long can the capacitor susta..

  What condition is relation in na-nd nd no good approximation

Compensation occurs when a semiconductor is doped with both donor and acceptor dopants. Using the fact that n0p0=ni^2 (mass action law) and p0+Nd=n0+Na (charge neutrality assuming all dopants are ionized)

  How does this modify the matrix m

Start by using the wave equation update, Equation (14.5), and then make the correct modifications near the TF/SF boundary, referring to Figure 7.3. For a single TF/SF boundary, how does this modify the matrix M?

  What are the main components of the current account

What are the main components of the current account? Give one credit and one debt item.

  Explain the linear relationship between ia and phi

A series-connected dc motor has RF+RA = .6 ohmns and draws IA = 40 A from the dc source voltage VT = 220 V, while running at 900 rpm. What is the speed for IA = 20 A Assume a linear relationship between IA and phi.

  Explain what determines which region the transistor is in

What is the difference between the saturation and active regions of a BJT. What determines which region the transistor is in.

  Write a program to determine the total impedance

Given the impedance of each element in rectangular form, write a program to determine the total impedance in rectangular form of any number of series elements.

  Explain which parameter of an fm transmission determines

Do either or both of the reasons you gave in part (a) above also apply to a point to point voice link using frequency modulation? c. Which parameter of an FM transmission determines whether it is wideband or narrow band?

  For the series parallel network of given figure calculate zt

For the series-parallel network of given figure: - Calculate ZT, Determine I,  Determine I1, Find I2 and I3, and  Find VL.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd