Find the capacity of the column with 1% reingforcement

Assignment Help Civil Engineering
Reference no: EM13545655

A circulatr concrete column with a diameter of 8" has spiral reinforcing. Find the capacity of the column with 1% reingforcement. Find the capacity of the column with 8% reinforcement.

Use rebar arrangement that is close for above. Calc Pn

Reference no: EM13545655

Questions Cloud

Use the conveyance method to verify the results : A drainage channel had a cross section that may be approximated as a trapezoidal section with a bottom width of 15 feet and a side slope of 1.5H:1V. If the channel drops 2.5 feet per mile.
Determine the size of the watershed in acres and then : The 1-hr UH in the table was recorded for a particular watershed. Determine the size of the watershed in acres and then convert the 1-hr UH into a 3-hr UH for the watershed.
Determine the magnitude of the largest elastic load p that : The 10-mm-diameter steel bolt is surrounded by a bronze sleeve. the outer diameter of this sleeve is 20 mm, and its inner diameter is 10 mm. if the yield stress for the steel is
What is the maximum weight of the crate that the system can : Rope BCA passes through a pulley at point C and supports a crate at point A. Rope segment CD supports the pulley and is attached to an eye anchor embedded in a wall. Rope segment BC creates an angle of = 74.0 with the floor and rope segment CD
Find the capacity of the column with 1% reingforcement : A circulatr concrete column with a diameter of 8" has spiral reinforcing. Find the capacity of the column with 1% reingforcement. Find the capacity of the column with 8% reinforcement.
Sketch how you will place the bars and calculate : Concrete cover on both sides. Sketch how you will place the bars and calculate the location of the effective depth. Place as many bars in the lower layers as possible.
Determine for each case the ration of the total energy : Consider two cases: (1) a constant wind velocity that is twice the mean wind velocity and operating half the time; and (2) a constant wind velocity that is three times the mean wind velocity operating one-third of the time. At all other times, the wi..
Design a one way slab to support a uniform live load : Design a one way slab to support a uniform live load of 300 psf. The beam is simply supported with a span of 20 ft. Use a reinforcement ration ( Ps) of 0.008 Use f'c=3000 psi and fy=60000 psi.
The angle measured counterclockwise between line ab and : The true azimuth of line AB is 193 degrees 20'. The angle measured counterclockwise between line AB and another line AC is 205 degrees 10'. The true azimuth of line AC is:

Reviews

Write a Review

Civil Engineering Questions & Answers

  What landfill area will be required for solid waste disposal

Solid waste will be applied in 0.6 m "lifts" and will be compacted to a depth of 0.3 m. Daily cover soil will be applied to a depth of 0.15 m for the first four days of the operation in any week. At the end of the fifth day, a "weekly cover" layer..

  Find the settling velocity of a 20 µm diameter particle with

Find the settling velocity of a 20 µm diameter particle with density 1500 kg/m3. If this particle had been hurled to a height of 8,000 m during a volcanic eruption, estimate the time required to reach the ground

  Calculate kg per day of sludge process if sludge is solid

The effluent contains 20 mg/L of solids and 20 mg/L of BOD the biological treatment process produced .32 kg of bacterial solids per kg of BOD removed

  Determine the tension in each wire that are attached

A horizontal circular plate weighing 60-lb is suspended from three wires that are attached to a support at D and form 30 degree angles with the vertical. Determine the tension in each wire.

  What would the aquifer specific storage be for the porosity

A confined aquifer has a specific storage of 2.5 * 10^-6 /m . The porosity is .20 and the water compressibility is 5 * 10-10/Pa.For the aquifer skeleton compressibility you just calculated, what would the aquifer specific storage be if porosity were ..

  Determine the friction angle and shear strength

Normal load at failure was 93.8N with a maximum shear load of 38.7N. Find stresses on the failure plane, sketch a graph showing these on the shear stress and normal stress axes. Find the friction angle and shear strength.

  Provide a reasonable design for a efficient esp treating

The particles have an effective drift velocity of 10.0 cm/s. Specify the total plate area, channel width, number and size of plates, number of electrical sections (total and in direction of flow), and total corona power to be supplied, and estimat..

  Find the probability that temperature exceeds 58 degree f

The following data are the temperatures (in °F) of effluent at discharge from a sewage treatment facility on consecutive days: 43 47 51 48 52 50 46 49 45 52 46 51 44 49 46 51 59 45 44 50 48 50 49 50

  How high did the ball roll before it momentarily stopped

A solid ball starts to roll up a hill with an initial velocity of 50m/s. The ball has a mass of 20 Kg with a 0.75 m radius. How high did the ball roll before it momentarily stopped

  Find the flow rate per unit thickness for a section midway

Two piezometers are located 1000 ft apart with the bottom located at depths of 50 ft and 350 ft, respectively, in a 400-ft-thick unconfined aquifer. The depth to the water table is 50 ft in the deeper piezometer and 40 ft in the shallow one.

  What is the total volume of the vocs emitted each day

Assume that there were 1,100,000 vehicles making a 28.5-mi round trip per day, the average vehicle emission rate for VOCs is 1.3 g/VM , and the molecular weight of the VOC emissions from the mobile sources can still be represented by that of metha..

  A freeway on a level terrain carries a volume

A freeway on a level terrain carries a volume of 4500 veh/hr onfour 11-foot lanes in one direction. the vehicle mix is 75%passenger cars, 10% trucks, 10% buses and 5% recreational vehicles.lateral obstructions are located at a distance of 5 ft on the..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd