Find the capacitance per unit area between the plates

Assignment Help Electrical Engineering
Reference no: EM13280424

1. Let potential V = 10x2 in free space, Find
(1)electric field E;
(2) volume charge density ?v;
(3) energy density;
(4) total energy within 1 <x, y, z< 1.

2. A line current I flows along y axis from A(0,-3,0) to B(0,4,0). I is 2 A. Find:
(1) magnetic flux density B from Biot-Savart's Law at point P(2,8,-7);
(2) magnetic vector potential A at this point.

3. Conducting plates at z=5m and z=15m are held at potentials -10V and 10V, respectively. If the region between the plates is a homogeneous dielectric with epsilon= 2 epsilon(0), solving the Laplace equation to find:
(1) the potential distribution V(z) between two plates;
(2)the capacitance per unit area between the plates.

4. The electric field of a uniform plane wave propagating in lossless isotropic medium is
E(x,t) = 60(pi)cos(3 10 t + 4x) ay V/m. The magnetic field at point (0,0,0) when t = 0 is 1A/m. The unit of t is second and the unit of x is meter. Find:
(1) the phase velocity vp;
(2) the wave impedance (namda) of the media;
(3) the relative dielectric constant ?r and relative permeability (mu)r;
(4) the time domain expression for magnetic field;

5. The plane y = 2x separates two isotropic uniform materials. For y < 2x (region 1), (epsilon)r1 = 3; and for y > 2x (region 2), (epsilon)r2 = 5.
Assume D1 = 2ax - 3ay + 5az nC/m2 in region 1;
(1) Find the angle D2 makes with D1;
(2) Find E2 in region 2;

Reference no: EM13280424

Questions Cloud

How much torque must be exerted by the friction force : The last exhibit had a cylinder of mass 1.2 kg and radius .2 meters rolling down an incline with a linear velocity of 2 m/s. How much torque must be exerted by the friction force
Find the constants of arm cd of a balanced ac bridge : A balanced ac bridge has the following constants arm AB, R= 2,000Ω in parallel with C= 0.047μF; arm BC, R=1,000Ω in series with C= 0.47μF; arm BC, R=1000Ω in series with C= 0.47μF; arm CD, unknown ; arm DA, C= 0.5 μF.
Explain the empirical formula of the iron complex : The resulting equations are y=1.2550x + 0.0707 and y=-1.2550x + 1.3377. Determine the overall mol fraction of each ion, the n value, and the empirical formula of the iron complex
Blood glucose concentrations of a normal subject : The enzymes are present to catalyze the reactions. the following are sequential enzyme reactions in a pathway - the cells immediately downstream from the thrombus were deprived of oxygen and , as a result, increased:
Find the capacitance per unit area between the plates : The electric field of a uniform plane wave propagating in lossless isotropic medium is E(x,t) = 60(pi)cos(3 10 t + 4x) ay V/m. The magnetic field at point (0,0,0) when t = 0 is 1A/m. The unit of t is second and the unit of x is meter.
Explain what is the total vapor pressure above the solution : A solution is composed of 1.00 mol cyclohexane (P cy=97.6 torr) and 2.20 acetone (P ac=229.5 torr). What is the total vapor pressure above this solution
Calculate the spring force exerted on the object : A 3kg object attached to a spring oscillates on a smooth horizontal surface. calculate the spring force F(t) exerted on the object versus time t.
What is the portfolio weight of stock a : You have a portfolio consisting solely of stock A and stock B. The portfolio has an expected return of 9.8 percent. Stock A has an expected return of 11.4 percent while stock B is expected to return 6.4 percent. What is the portfolio weight of sto..
Explain the basis of the positions in the periodic table : On the basis of their positions in the periodic table, select the atom with the larger atomic radius in each of the following pairs.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Dtermine the amount of power supplied by the voltage source

a) Find the value of the voltage source "E"that is required to provide a 10V across the 10kΩ resistor. What are the values of [V10k/E] and [V3.3k/V10k] b) Dtermine the amount of power supplied by the voltage source when E= 20V.

  Calculate critical frequency for the input low pass network

Calculate: Critical frequency for the input low pass network, and the output low pass network, estimate the values for Cbe, Cjc, Cbc, and Cje. Concider the resistance of the signal sourceRs to be equal to the 1 ohm resister in series with the source.

  Determine the complex reflection coefficient at the load

A 50-O lossless line is terminated in a load impedance of 50 + j 100 O. If the wavelength is 20 cm, determine (a) the complex reflection coefficient at the load, (b) the standing-wave ratio,

  What will then be the frequency at which the loop gain given

An op-amp has a single-pole, open loop response with the dc open loop gain of A0=20,000 and the pole frequency at fp=40 Hz. A. If this amplifier is connected as a non-inverting amplifier configuration with the closed loop gain

  What will be the voltage measured across the motor terminals

Suppose a resistor whose value is equal to the motor resistance is connected across the motor terminals and the motor is spun at 200 RPMs. What will be the voltage measured across the motor terminals

  Calculate the added inductance that leads to a conduction

Assume that an additional inductance can be inserted in series with the load. also assume that the converter has no freewheeling diodes. Calculate the added inductance that leads to a conduction period of 180 degrees when alpha = 30 degrees.

  What is the magnetic field at z at the time t

A parallel-plate transmission line is comprised of two perfect conductors of width w lying in the planes x = 0 and x = d. At z =z1 and the time t, the power flow is 8 kw and the electric and magnetic fields are 5000 V/m and 0.5T.

  Find the electric field at the origin in terms of q

In the plane z=5 there is a ring with a 3cm radius with its center on the z axis. The ring has a uniformly distributed charge Q. The origin 0,0,0 is at a small sphere with a mass of 0.5kg and a charge of -Q.

  Calculate amount of substance transferred into the patient

If a patient is on a drip with a drip rate of f(t) = 150e^0.0167t mL/hr, calculate the amount of substance transferred into the patient over a time period of 10 hours, use time intervals of 1 hour. Compare

  What is the probability the queen is a carrier

If she is a carrier, then each prince has a 50-50 chance of having hemophilia, independently of the other princes. If the queen is not a carrier, the prince will not have the disease. Suppose the queen has had three princes, each without the disea..

  Explain scada system

Explain the function of the HMI in a SCADA system.

  Find the at steady state instantaneous rate of heat transfer

The outer surface temperatures of the brick and insulation are 1260 degreeR and 560 degreeR, respectively , and there is perfect contact at the interface between the two layers. Determine at steady state the instantaneous rate of heat transfer

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd