User Account

All Pages

Find the average value of v peak to peak amplitude

Assignment Help Electrical Engineering
Reference no: EM13280643

Consider a half-wave rectifier circuit with a triangular wave input of 5-V peak to peak amplitude and zero average, and with R=1kΩ. Assume that the diode can be represented by the constant-voltage-drop model with Vd=0.7V. Find the average value of vo.

Reference no: EM13280643

Questions Cloud

Find expressions for current-power and stored energy : The voltage across a 1-µF capacitor is given by v(t)=100 e-100t . Find expressions for the current, power, and stored energy. Sketch the waveforms to scale versus time.
Velocity problem : If he struck a ball with the a speed and launch angle that would result in a maximum 120m horizontal range on Earth, how far would it go?
How long can printed circuit traces before being considered : For a 32 bit CMOS 5 volt microprocessor that has a 32 bit address bus and a separate 32 bit data bus, and the processor has a 1 nS rise time and 0.5 nH of ground inductance on a board made from glass epoxy material.
Determine the moons radial acceleration : An undiscovered planet, many lightyears from Earth, has one moon in a periodic orbit. calculate the moon\'s radial acceleration
Find the average value of v peak to peak amplitude : Consider a half-wave rectifier circuit with a triangular wave input of 5-V peak to peak amplitude and zero average, and with R=1kΩ. Assume that the diode can be represented by the constant-voltage-drop model with Vd=0.7V. Find the average value of..
What is the expression for the restoring force of the spring : Potential energy of a not obeing Hooke's law spring is given by the equation U(x)=5.00(J/m)x - 2.00(J/m3)x3, What is the expression for the restoring force of the spring
How many silicon atoms are present for each lattice impurity : Assume that each donor atom contributes one free electron to the silicon lattice. For an n-type doping of 5x10^15 cm-3, how many silicon atoms are present for each lattice impurity
What is tension in the string at the lowest point : A small rock with mass 0.200 kg is fastened to a massless string with length 0.750 m to form a pendulum. What is tension in the string at the lowest point
Determine how much power is dissipated by each component : John take a 1kΩ resistor, the 10μf capacitor, and the 10 mH inductor, and one by one connects them across one of the outlets in his dorm room. How much power is dissipated by each component (as a function of time)

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find b1 and angle that b1 makes with normal to interface

a) Assume B1 = ax2 - ay10(mT), find B2 and the angle that B2 makes with the interface. b) Assume B2 = ax10 +ay2(mT), find B1 and the angle that B1 makes with the normal to the interface.

  Find the series element for circuit has lagging power factor

find the series element or elements that must be in the enclosed container to satisfy the following conditions. a. average power to circuit = 300W b. circuit has a lagging power factor

  Find the resistance in series with armature to limit current

1. A 240 dc motor takes an armature current of 20A when running at 960 r/min. The armature resistance is 0.2ohm. Determine the no load speed, assuming negligible losses. 2. A 220 dc shunt motor has a srmature resistance of 0.3ohm.

  Design the electrical system for a shopping center

Design the electrical system for a shopping center with 500,000 square feet at least 30 spaces of three different sizes (5,000, 10,000 and 25,000 sf). They may be offices, banks, restaurants and shops.

  For what range of values of a is the system stable

For what range of values of a is the system stable?

  Determine what is the frequency of the wave in hz

A uniform plane electromagnetic wave propagates in a lossless dielectric medium. The electric field in the wave has the instantaneous expression E(z,t) = iy 3 sin(3pi.109t + 100piz 600), V/m. i) What is the frequency of the wave in Hz

  Detrmine whether the f is a proper rational function

Sometimes the partial fraction expansion is not neede in finding the inverse Z-transform -instead the properties of the transform can be used. Consider the function F(z)= (z+1)/z^2*(z-1)

  Find the unknown load impedance

The unknown input impedance of a horn antenna operated at a frequency of 300MHz is measured using a slotted transmission line and a Smith Chart. When the antenna is connected to the slotted line, the VSWR on the line is measured to be 4

  What is path attenuation between transmitter and receiver

What is the path attenuation between transmitter and receiver at a frequency of 1.2 GHz and a distance of 11,000. Given: f = 1.2GHz d = 11,000 mi. Calculate the path attenuation; dB = 37dB + 20 log f + 20 log d = 37 + 20 log 1.2^9 + 20 log 11,000

  What is the magnitude of the electric field

Each of the protons in a particle beam has a kinetic energy of 3.30 10-15 J. What is the magnitude of the electric field that will stop these protons in a distance of 1.05 m

  Express function in its canonical or standard product of sum

Consider the function F = x · y + x(not) · z. a) Expand the function to its canonical or standard sum of products (SOP) form. b) Express the function in its canonical or standard product of sums (POS) form.

  What is max amplitude of noise spikes to be tolerated

A TTl gate with VIH (min) = 2.25 V and VIL (max) = 0.65 V is being driven by a gate with NOH (min) = 2.4 V and VOL (max) = 0.4 V. What is the maximum amplitude of noise spikes that can be tolerated on the inputs in both the HIGH and LOW states

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd