Find the average force required to stop the bullet

Reference no: EM13334820

A bullet of 0.0500 kg is fired into a block of wood. Knowing that the bullet left the gun with a muzzle velocity of 350. m/s, and the bullet penetrates .15 m into the block of wood, determine:

a) The average force required to stop the bullet.

b) The impulse exerted by the wood on the bullet.

c) The change in momentum of the bullet.

Reference no: EM13334820

Questions Cloud

Define a reaction mechanism : Propose a reaction mechanism, including all appropriate arrows, to show how (S)?2?bromo?2? fluorobutane reacts to give (S)?2?fluoro?2?methoxybutane. Has this reaction gone with retention or inversion of configuration

May the law firm release the contents of the transcript : 1. May the law firm release the contents of the transcript to either the insurer, the insured, or the other employee? If so, under what circumstances?

What amount is jarvie required to include in taxable income : Jarvie loves to bike. In fact, he has always turned down better paying jobs to work in bicycle shops where he gets an employee discount. At Jarvie's current shop, Bad Dog Cycles, each employee is allowed to purchase

State chemical equations for the reaction of calcium : Write chemical equations for the reaction of calcium with the following substances, making sure that the numbers and kinds of atoms are the same on both sides of the equations.

Find the average force required to stop the bullet : A bullet of 0.0500 kg is fired into a block of wood. Knowing that the bullet left the gun with a muzzle velocity of 350. m/s, find The average force required to stop the bullet

He presides as a municipal judge : Can a lawyer use his law firm's letterhead to communicate with litigants in a court over which he presides as a municipal judge?

What must the length of the rod be : A small pole (uniform, thin) that has mass 4.05 kg and can pivot about an axis perpendicular to the length of the pole and through its center. What must the length of the rod be

Prepare current liability section of red banks balance sheet : Prepare journal entries to record the transactions and prepare adjusting entries on October 31 to record accrued interest.

Compute the ph when 5.86 g of naclo is added hclo : Calculated molarity of HClO: .50/.4541=.174 2) calculated molarity of NaClO: (5.86g/74.45 g/mol)/(.4541L=1.10) 3) Set up ICE chart and calculated H+(x). x=(3E-8)(1.10)/(.174) = 1.90E-7 4) took negative log of 1.90E-7 to get a pH of 6.72.

User Account

All Pages