Find the appropriate useful power for a pump

Assignment Help Electrical Engineering
Reference no: EM131262893

The layout of the required water demands for a proposed industrial complex are shown in Fig. P11.42. Design an appropriate network and determine the appropriate useful power for a pump to meet the demand needs. The design criteria are as follows:

1. The lower reservoir supplies water to the system. The upper reservoir supplies water for emergency use only, such as fire, line breaks, and so on; under normal operation, there is no flow into or out of it.

2. Under normal operation, pressures in the network can range between 80 and 120 psi.

3. Two gate valves are to be placed in each line (one at each end) to isolate it in case of a break or for needed maintenance.

4. All demands must be met in case of a single line break with minimum allowable pressures of 20 psi.

5. Pipes are cast iron, with the following standard diameters available: 4, 6, 8, 12, 16, 20, 24, 30, 36, 42, and 48 in. Pipes can be placed anywhere within the region.

2185_624c8af0-5a46-42d5-86b2-ec3546b45b82.png

Reference no: EM131262893

Questions Cloud

Which of the six ways to overcome resistance to change : Which of the six ways to overcome resistance to change do you believe is the most important? - Select two sport organizations and discuss the differences between their cultures.
How has diversity affected you personally : Do you believe that online surveys are an effective method for analyzing the effectiveness of Title IX in the United States?
What is the relationship between tax reform and a flat tax : Which forces in Reagan administration supported the idea? Why? What is the relationship between tax reform and a flat tax? Which oppposed it?
What does this impedance look like at low frequencies : Solve for the string displacement y(x,t) and determine the resonance frequencies. Find the formula for the mechanical impedance at the drive point x = L.
Find the appropriate useful power for a pump : The lower reservoir supplies water to the system. The upper reservoir supplies water for emergency use only, such as fire, line breaks, and so on; under normal operation, there is no flow into or out of it.
Should government get involved in breaking the glass ceiling : Should the government get involved in breaking the glass ceiling? Why or why not? If yes, what should the government do? State pros and cons of government involvement.
What counter arguments might there be inherent in projet : What strategies do you believe will work most persuasively on that audience? Are you comfortable employing these strategies in your own writing? What counter arguments might there be inherent in your project? How much research will you have to conduc..
In what situations you think ads use team building skills : The change variable in AD jobs has primarily been what type of change? - In what sorts of situations do you think ADs use team-building skills?
How do you feel about bona fide occupational qualifications : How do you feel about bona fide occupational qualifications? -What are the components of a job analysis? - What do you think about promoting from within for pro baseball teams?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the thevenin equivalent circuit for the network

Find the Thévenin equivalent circuit for the network external to the resistor R in each of the networks of given figure.

  How much voltage wouldbe present across the capacitor

If an RC circuit is supplied with 24 VDC and the circuit is in its third time constant, how much voltage wouldbe present across the capacitor

  Design a multirange ammeter with ranges of 1-10ma

design a multirange ammeter with ranges of 1-10mA,0-100mA, and 0-1500mA, using a 5mA movement whose internal resistance is 3.8ohms. draw a circuit diagram of the meter.

  What is the minimum number of flip-flops that can be used

A finite state recognizer or sequence detector has one input (X) and one output (Z). The output is asserted high (Z=1) whenever the input sequence 1101 has been observed during the past four clock cycles, as long as 1110 has never been observed.

  What would be the worst-case variation in overall resistance

Assume all your standard value resistors are accurate to 0.1%. What would be the worst-case variation in overall resistance for your design (both high and low). How might you construct a resistive network using the smallest number of standard resis..

  Design a signal conditioning circuit for k-type thermocouple

Design a signal conditioning circuit for a K-type thermocouple, which produces output voltage of 0V-5V using a three terminal solid-state temperature sensor for reference junction compensation. The sensitivity of the sensor is 4mV/C.

  Calculate the reverse saturation current

If the diode carries a forward current of 100 mA at room temperature, calculate the reverse saturation current and the forward current if the temperature is raised by 50°C.

  Compare the cost of the resulting sum-of-product excitation

redesign the 1s-counting machine, assigning the states in the binary counting order (S0-S3=00,01,10,11). Compare the cost of the resulting sum-of-product excitation equations with the ones derived in the text.

  Which system ratio of bit energy to one-sided noise density

Assume a binary PCM system in which the system ratio of the bit energy to the one-sided noise density at the receiver input is 10 dB. Assume that the probability of error for any value of the independent variable off the scale can be approximated ..

  Calculate the full-load current delivered by the controller

A 92in*24in*32in, 450kg Square D motor controller is used to drive a 1600 hp,2400V,3-phase,60Hz squirrel-cage motor. a. assumeing the motor has a minimum efficiency and power factor of 96%and 90%,respectively

  Design a controller with a 4-bit state register

Design a controller with a 4-bit state register that gets synchronously initialized to state 1010 when an input reset is set to 1.

  Determine what the price of coal should be in per ton

The department of energy projects that between the years 1995 and 2010, the united states will need to build new power plants to generate an additional 150,000MW of electricity to meet the increasing demand for electric power.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd