Find the appropriate electrical length of the line

Assignment Help Electrical Engineering
Reference no: EM13272148

An open-circuited 50ohm microstrip transmission line is used in a microwave amplifier circuit to provide a capacitance of 3.2 pF at 2.3 GHz.
(a) Find the appropriate electrical length of the line.
(b) Find the lumped element values of the open-circuited line designed in part (a) at 2 GHz and 2.6 GHz.

Reference no: EM13272148

Questions Cloud

Find the smallest possible high temperature for engine cycle : A heat engine, in each cycle, takes in 750 J of heat and exhausts 300 J of heat. what is the smallest possible high temperature for the engine cycle
Compute the enthalpy of reaction for oxygen : Use the following data on oxygen solubility to calculate the enthalpy of reaction for oxygen dissolving into water.
Calculate the number of moles of co 2 : Calculate the number of moles of CO 2
What is the pretax operating cash flow break-even : IronVerks Ribshack has total fixed costs of $8,500 per month. It sells rib plates for $15 each, and the variable cost of providing each plate is $10. What is the pretax operating cash flow break-even point for IronVerks?
Find the appropriate electrical length of the line : An open-circuited 50ohm microstrip transmission line is used in a microwave amplifier circuit to provide a capacitance of 3.2 pF at 2.3 GHz. (a) Find the appropriate electrical length of the line.
What was swan depreciation and amortization expense : Swan's Bicycle Boats had a degree of accounting operating leverage equal to 1.50 during the most recent period. If the firm's EBITDA was $5,000 and its fixed costs were equal to $1,750, then what was Swan's depreciation and amortization expense du..
What is input power required to obtain output from amplifier : 1. If the power gain of the amplifier is +42dB, what is the input power required to obtain the full output from the amplifier 2.If the voltage gain of the amplifier is 60dB, what is the required input voltage if the amplifier is to produce its rate..
Explain the same wavelength be reflected on the same side : Light impinges on a 1485 line per mm diffraction grating at an angle of incidence of 39.5 degrees. What wavelength, in nm, will be reflected in the first order at an angle of 14 degrees on the other side of the normal to the grating.
Develop an argument in response to problem of assimilation : you are to develop an argument in response to the problem of assimilation as experienced by the characters in Gish Jen's short story "In the American Society"

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain the ohmic resistance of the photoresistor changes

A photoresistor is connected series to a battery of 10 V with internal resistance of 5 Ohms. The ohmic resistance of the photoresistor changes by time through the day and expressed as: RLDR=20-(10/t) .

  Determine coefficients c1-c2-c3 and c4 used for projection

determine the coefficients c1, C2, c3, ,c4 used for projecting s onto v(1).v(4),respectively Using v(1), v(2) and v(3) only, find s*, an approximation for s using the orthogonal projection method. Determine the error vector s* - s.

  Sketch the unit step response of the system

Sketch the unit step response of the system below. Show the magnitude of the steady state on the c(t) axis of your response curve and the value of the time constant on the t axis. T(s)=C(s)/R(s)=5/s+2.5

  Discuss briefly the implications of the values of t1

Discuss briefly the implications of these values of T1 for ultrasonic imaging. Repeat the calculations above with the angle of incidence of the ultrasound beam now being 60 degrees.

  Define design a synchronous counter using j-k flip-flops

Design of sync counter 0010 to 1101 using JK flip flops, Design a synchronous counter using J-K flip-flops that will count from 0010 to 1101 repetitively.

  Calculate the electric field at the origin

Three positive point charges, each with q = 3 nC, are located at the corners of a triangle in the x-y plane, with one corner at the origin, another at (2 cm, 0, 0), and the third at (0, 2 cm, 0). Find the electric field, E', at the origin.

  What is the power generation in watts of generator

A small generator produces 10 C of charge every ten seconds across a potential difference of 100V. What is its power generation in Watts

  Design a tunk circuit with resonant frequency

Design a tunk circuit with resonant frequency of 10 kHz and bw of 500 Hz. show your design equation, then use a circuit simulator package to prove your design is correct. you must attach both your design calculation and computer output.

  Find the channel capacity c and the input probabilty

(a)Write out the channel matrix P and sketch its model formed by 2 identical parallel binary system channels(assume X-over prob is pdash) (b)Find the channel capacity C and the input probabilty that achieve it.

  How to close the temperature switch turns on

In a motor control system, one master stop pushbutton (Stop) is available for stopping the operation at any time. If the temperature switch (TSW) is closed, pressing the red pushbutton (RedPB) will turn on both motors M1 and M2.

  How much current is there through the resistor

a 10 ohm resistor is connected across a 12 v battery. How much current is there through the resistor?

  Calculate horizontal distance of point from lower support

An overhead line conductor is supported at water crossing from two towers, the heights of the supports being 30 and 34.2 m respectively , above the water level , with a horizontal span of 325 m.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd