Find that the average man in our sample weighs 180 pounds

Assignment Help Civil Engineering
Reference no: EM13318739

Suppose we want to estimate the average weight of adult males in greater metropolitan Atlanta area. We draw a random sample of 1,000 men from a population of 1,000,000 men and weigh them. We find that the average man in our sample weighs 180 pounds, and the standard deviation of the sample is 30 pounds. What is the 95% confidence interval?

Reference no: EM13318739

Questions Cloud

Does the second law require that the decrease in entropy : An insulated system contains two solid blocks in contact with each other; one hot and the other cold. After heat transfer over some time, thermal equilibrium is established in the container.
What is the secondary current : A transformer steps up the 120 V rms AC power line voltage to 23 kV rms for a TV picture tube. what is the secondary current
Determine what is the change in entropy of the water : A piston-cylinder device contains 2 kg saturated water vapor at 600 kPa. The water expands adiabatically until the final pressure is 100kPa. And 1,465 kJ work is produced.
Compute the molarity of the hydroxide ion for the two tests : The second time, 1.3mL is added to reach the end point. How would I calculate the molarity of the hydroxide ion (OH-) for the two tests
Find that the average man in our sample weighs 180 pounds : Suppose we want to estimate the average weight of adult males in greater metropolitan Atlanta area. We draw a random sample of 1,000 men from a population of 1,000,000 men and weigh them.
Calculate value of cohesion and angle of internal friction : A cylindrical soil sample fails under an axial vertical stress of 160 kN/m^2, when it is laterally unconfined. The failure plane makes an angle of 50 degrees with the horizontal.
Evaluate the mole fraction and partial pressure of each gas : Calculate the mole fraction and partial pressure of each gas, and the total pressure in the tank. a) Boron trifluoride - mole ratio - partial pressure b) Sulfur hexafluoride -mole ratio -partial pressure
Heat and humidity in an underground mining situation : List the main sources of heat and humidity in mines and briefly describe the methods that can be used to control heat and humidity in an underground mining situation.
How large a sample must we take in order to be confident : how large a sample must we take in order to be a) 95% b) 90% c) 99 d) 99.73% confident that the error in the estimated mean lifetime will not exceed 20 hours.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Define water circulating through it at the rate

A 4 X 8-ft solar collector has water circulating through it at the rate of 1.0 gallon per minute while exposed to sunlight with intensity 300 Btu/ft^2-hr.

  Determine the flow rate of a 2-inch diameter glass pipe

A 2-inch diameter glass pipe is connected to a pipe network in which the pressure is 70 psig. If the length is 300 ft and the outlet is 10 ft above the pipe, determine the flow rate.

  Find what is the net force of the water on the block

A horizontal het of water at 5 degrees celsius strikes a block and is deflected upward 30 degrees. The mass flow rate of the water is 1.75 kg/s. The mass of the block is 1.30 kg. The jet has a cross sectional area of 10 cm^2.

  What is the relationship between drag forces for two plates

Two different fluids flow over two identical flat plates with the same laminar free-stream velocity. Both fluids have the same viscosity, but one is twice as dense as the other. What is the relationship between the drag forces for these two plates

  Derermine the velocity and acceleration of point p

At the same instant the frame h, not the horizontal blade, rotates about a vertical axis with a constant angular velocity w=0.9 rad/s, measured relative to h

  How many students have heights equal to 68 inches

how many students have heights, (a) Greater than 72 inches (b) Less than or equal to 64 inches (c) Between 65 and 71 inches inclusive (d) equal to 68 inches * Assume the measurements to be recorded to the nearest inch.

  Determine the time needed for the velocity to become v

When a particle falls through the air, its initial acceleration a=g diminishes until it is zero, and thereafter it falls at a constant or terminal velocity v_f . If this variation of the acceleration can be expressed as a=(g/v^2_f)(v^2_f-v^2)

  Determine maximum shearig stress in the shaft

a hollow steel shaft with an outside diameter of 400 mm and inside diameter of 300mm is subjected to the torque of 300 Kn. The modulus of rigidity for the steel is 80 GPa.

  Indicate values for optimum water content and max density

Compacted one cylinder of the soil describes above problem 1 to compare the new results with shown above. The data obtained included a water content of 32.5% and a total density of 121.9 pcf. Comment on these new findings.

  Determine what is the final weight in pounds and newtons

A container weights 2.06lb. It is filled with 1.09ft^3 of water at 25 degrees Cel. What is the final weight in pounds and newtons

  Compute the density and unit weight of the compacted soil

The mass of the compacted soil specimen is 1.91 kg and its water content is 14.5%. Using a specific gravity of solids of 2.66, compute the degree of saturation, density and unit weight of the compacted soil

  Estimate amount of lime required for specified ferric dose

estimate the mass and volume of sludge produced from unreated wastewater without and with the use of ferric chloride for the enhanced removal of TSS. Also, estimate the amount of lime required for the specified ferric schloride dose.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd