Find power dissipated in amplifier - efficiency of amplifier

Assignment Help Electrical Engineering
Reference no: EM131028074

A certain amplifier has an input voltage of 100 mV rms, an input resistance of 100kΩ, and produces an output of 10Vrms across an 8-Ω load resistance. The power supply has a voltage of 15 V and delivers an average current of 2 A. Find the power dissipated in the amplifier and the efficiency of the amplifier.

Reference no: EM131028074

Questions Cloud

Determine efficiency and power dissipated in them amplifier : Under high-signal test conditions, a certain audio amplifier supplies a 24 V rms 1-kHz sinusoidal voltage to an 8- Ω load. The power supply delivers 4 A at a voltage of 50 V to the amplifier. The signal power supplied by the input source is neglig..
Do a network diagram and a pdm for the given project : Do a network diagram and a PDM for this project. Do a scenario analysis for the installation of windows lasting four days. Input all the information provided by Craig into Microsoft Project.
General environmental analysis-technological segment : The men's warehousing: General Environmental Analysis, i.e Economic segment, political/ Legal segment, socio-cultural segment, Technological segment, Global segment and Driving Forces.
Would this affect their status as independent contractors : Suppose Celia and Mary want to require the men, when they are not selling, to do inventory and clean up the boutique. Celia and Mary also set the men’s working hours. Would this affect their status as independent contractors? If so, can they still pa..
Find power dissipated in amplifier - efficiency of amplifier : A certain amplifier has an input voltage of 100 mV rms, an input resistance of 100kΩ, and produces an output of 10Vrms across an 8-Ω load resistance. The power supply has a voltage of 15 V and delivers an average current of 2 A. Find the power dis..
What is your current approach to personal evaluation : What is your current approach to personal evaluation and how do you plan to sustain teach ability and encourage evaluation in your life while completing the master’s program?
Benefits program in a large organization : Based on the information discussed in the chapter, how would you oversee the design (or redesign) of a benefits program in a large organization? What issues would you consider?
Draw the cascade connection of two amplifiers : Draw the cascade connection of two amplifiers. Write an expression for the open-circuit voltage gain of the cascade connection in terms of the open-circuit voltage gains and impedances of the individual amplifiers.
Health care costs are out of control : Discuss the following statement: “Health care costs are out of control in the United States, and increasing conflicts between employers and employees are likely as employers try to reduce their health-benefits costs.”

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Can one use a remote by reflecting signal through a mirror

Can one use a TV remote by reflecting the signal through a mirror?

  Determine the thermal equilibrium recombination

A semiconductor, in thermal equilibrium, has a hole concentration of p0 = 2x1016 cm-3. The minority carrier life time = 3x10-7 s. (Assume, ni = 1010 cm-3)

  Find the specific heat of the unknown object

It is necessary to determine the specific heat of an unknown object. The mass of the object is 170.0 g. It is determined experimentally that it takes 20.0 J to raise the temperature 10.0° C. Find the specific heat of the object.

  What is the peak value of the instantaneous power absorbed

A load consisting of a 480 ohm resistor in parallel with a (5/9) uF capacitor is connected across the terminals of a sinusoidal voltage source, vg, where vg=240cos5000t V. a) What is the peak value of the instantaneous power delivered by the source

  Determine the total current required for all loads operating

A 117 V(rms), 60Hz household circuit has two 75 Watt lights,PF=1, and a fan using 500VA at 0.78 PF (lagging). A) Draw the circuit, representing each load by its impedance. Include the switches for each load. B) Determine the total current required fo..

  Consider a cartesian co-ordinate system on a plane the

consider a cartesian co-ordinate system on a plane the plane lines on the x- and y-axis. a current of 100 a is

  Write down state and output equation in canonical form

Given transfer function of dynamic system: T(s)= (2s^2 + 2s + 3) / (s^3 + 4s^2 + 6s + 10). write down state equation and output equation in Controllable Canonical Form and in Observable Canonical Form.

  Find what is the voltage at the receiver antenna

The received power at a receiver antenna is -38 dBm. If the system impedance is 50 Ohms, what is the voltage at the receiver antenna

  What is the total force acting on each charge

Three test charges, each with a charge of +1x10-6 C, are located at the points of an equilateral triangle. If the legs of the triangle are 10 cm long, what is the total force acting on each charge? (Assume vacuum, or dry air.)

  Propsoal about parallelized conjugate gradient

Prepare a research paper about parallelized conjugate gradient, you need to do propsoal about parallelized conjugate gradient

  Describe the operation of a current mirror

What effect do internal capacitances in the transistor model have on practical performance of a real system? How would you use these model values to predict system performance?

  Design a finite statemachine that detects the sequence

Design a Finite StateMachine that detects the sequence 0110. The FSM shouldnot detect overlapping sequences. Additional design criteria include: The FSM should change state on thepositive edge of the clock signal.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd