Find percent of motion transmitted to the instrument panel

Assignment Help Mechanical Engineering

Reference no: EM131143971

The instrument board of an aircraft is mounted on an isolation pad to protect the panel from vibration of the aircraft frame. The dominant vibration in the aircraft is measured to be at 2000 rpm. because of size limitation in the aircraft's cabin, the isolators are only allowed to deflect 1/8 in.

Find the percent of motion transmitted to the instrument panel if it weighs 50 lb.

Reference no: EM131143971

Questions Cloud

Determine the largest compressive load p : A short column is made by nailing four 1 X 4-in. planks to α 4 X 4-in. timber.

Write a report and answer following questions : Write a two page report along with the solution. - Review the Consolidated Statements of Earnings and Comprehensive Income for 2012 and 2011. What was the income tax expense for each year?

Calculate the stiffness required of the isolation pads : Calculate the stiffness required of the isolation pads to accomplish this design goal - It is desired to reduce the amplitude of the transmitted force by 80% using isolation pads.

Determine the largest offset that can be used : Knowing that the maximum stress after the offset is introduced must not exceed 4 times the stress in the tube when it is straight, determine the largest offset that can be used.

Find percent of motion transmitted to the instrument panel : Find the percent of motion transmitted to the instrument panel if it weighs 50 lb.

What is the most influential factor in lifting : What is the most influential factor (i.e. multiplier) in lifting? The management style where the boss spends more time "on the floor" than in his/her office is called

Design base isolation system for electronic module of mass : What will the transmissibility be if the frequency of the base motion changes to 100 Hz? What if it reduces to 25 Hz?

What is the wavelength of the standing wave pattern : The speed of waves along the string increases with increasing tension in the string. Should the magnitude of M be increased or decreased in order to double the number of antinodes in the standing wave pattern. Justify your answer.

Calculate the damping ratio required : Calculate the damping ratio required to limit the displacement transmissibility to 4 at resonance for any damped isolation system.

User Account

All Pages