Find out the number of mols of hydrogen in the compound

Reference no: EM13226684

When a compound containing C and H is burned in oxygen, the reaction produces 0.90 mol of CO2 and 0.45 mol of H2O. Determine the number of mols of carbon in the compound. Determine the number of mols of hydrogen in the compound.

Reference no: EM13226684

Questions Cloud

Describe hydrogen fluoride is a highly reactive gas : Hydrogen fluoride is a highly reactive gas. It has many industrial uses, but the most familiar property of HF is its ability to react with glass. As a result, HF is used to etch glass and frost the inner surfaces of light bulbs.

What would be the minimum sample rate needed an ekg signal : What would be the minimum sample rate needed to adequately acquire an EKG signal Note that this problem is not as simple as it appears to be, because while the fundamental frequency may be relatively low, artifacts in the EKG may be at frequencies..

Explain what is the maximum ratio compatible with atp : what is the maximum [ATP]/[ADP][Pi] ratio compatible with ATP synthesis assuming that the number of protons trans-located per ATP formed is 2, the temperature is 25C and the change of pH is 0.75?

Design circuit using only two-three and four-input nand gate : Design a circuit that will add either 1 or 2 to a 4-bit binary number N. Let the inputs N3, N2, N1, N0 represent N. The input K is a control signal. The circuit should have outputs M3, M2, M1, M0, which represent the 4-bit binary number M.

Find out the number of mols of hydrogen in the compound : the reaction produces 0.90 mol of CO2 and 0.45 mol of H2O. Determine the number of mols of carbon in the compound. Determine the number of mols of hydrogen in the compound.

Describe briefly the nature of the organization : Describe briefly the nature of the organization itself, its Operations and Quality Management systems and how these systems improved and contributed to the organization's current success.

State what is the change in the measurement of the potential : What is the change in the measurement of the potential if a solution of 1.00x10-3 M NaF is exchanged for another solution of 1.00x10-4 M NaF?

Find out the value of the overall reaction : Determine the value of the overall reaction order in the rate law expression. Rate=k[A]^n [B]^m, from the following data.

What is initial value if the overhead values were considered : write an 8051 program that would generate a 200khz, 50% duty cycle, square wave at P1.0.Use Timer 0 for the delay. Ignore the overheads cycles due to the instructions in the loop. Assume 12 MHz clock. All data must be hex.

User Account

All Pages