Find out the mass flow rate of solids discharged

Reference no: EM13266175

Assume the discharge from a waste water plant has a flow of 30MGD with a solids concentration of 5 mg/L. Determine the mass flow rate of solids discharged in unit lb/day.

Reference no: EM13266175

Questions Cloud

Compute the grams of hcl that must be diluted : Calculate the grams of HCl that must be diluted to a volume of 1 liter to produce a concentration of 0.5M. Calculate the normality of 1 L of solution containing 45grams of NaOH.

Determine what is the common-mode rejection ratio : What is the common-mode rejection ratio (in dB) if the output voltage is measured to be 2.0 Vp-p when the input terminals are connected together and a 0.1 Vp-p voltage is applied between the inputs and ground.

How much does gain change when a load resistance given : A common-source FET amplifier has an RD = 1.0 k ohms. How much does the gain change when a load resistance of 1.0 k ohms is capacitively coupled to the drain

What is the temperature of the junction point : An iron bar 40 cm long is braised to a copper bar 40 cm long and of the same diameter. What is the temperature of the junction point

Find out the mass flow rate of solids discharged : Assume the discharge from a waste water plant has a flow of 30MGD with a solids concentration of 5 mg/L. Determine the mass flow rate of solids discharged in unit lb/day.

How many photons per second does this laser emit : A laser emits a light beam with a power of 5 mW. How many photons per second does this laser emit

Find out the stack-gas concentration in units of micro grams : The sulfur dioxide stack gas concentration from fossil fuel combustion is 2ppm(v). Determine the stack-gas concentration in units of micro grams/m^3 assume 0 degrees Celsius and1atm.

Find the angle the thread make with the vertical plates : A small object with a mass of one gram carries a charge of 1µC and is suspended by a thread between the vertical plates of a parallel-plate capacitor submitted to a voltage of 1 kilo volts

Find the angular acceleration of door after applying force : Assuming that the door is relatively thin, the moment of inertia will be the same as that of a rod rotating about an axis at its end. If the mass of the door is 10 kg and its width is 1.5 m, find the angular acceleration of the door after applying..

User Account

All Pages