Find noise powre spectrum at input to receiver amplifier

Assignment Help Electrical Engineering
Reference no: EM13281056

A wireless link has the following parameters:
Effective isotropic radiated power, EIRP|dB=50dBm
path loss, Lpath|dB=145dB
System losses, Lsys|dB=3dB
Rx antenna gain, Gr|dB=3dBi
Rx noise bandwidth, BW=100KHz
Rx amplifier available gain, G|dB=90dB
RX noise figure, F|dB=8dB
The noise temperature at the receiver antenna terminals is T0=290K.
1- Find the signal power at the input to the receiver amplifier.
2- Find the noise powre spectrum at the input to the receiver amplifier.
3- Find the signal-to-noise ratio at the receiver amplifier output.

Reference no: EM13281056

Questions Cloud

What is the maximum range to ensure good communications : The noise temperature at the receiver antenna terminals is T0=290K. The equipment and environment suggest that 6dB of margin be used to assure performance under all conditions. For reliable voice communications, a received signal should be 17dB ab..
Compute the temperature of the warm water mixture : A 100.0 mL sample of cold water at 21.3 C was added to a 75.0 mL sample of hot water at 55.1 C. Calculate the temperature of the warm water mixture.
Explain why fixed differential rate is much larger : Explain why fixed differential rate is much larger than floating differential rate in swap. For example, the fixed might be 2%, but the floating differential rate is only 0.3%
What is the resistance of the heater wire : An electric device, which heats water by immersing a resistance wire in the water, What is the resistance of the heater wire
Find noise powre spectrum at input to receiver amplifier : 1- Find the signal power at the input to the receiver amplifier. 2- Find the noise powre spectrum at the input to the receiver amplifier. 3- Find the signal-to-noise ratio at the receiver amplifier output.
Find the rate at which energy is transferred by conduction : A pond with a flat bottom has a surface area of 730 m2 and a depth of 2.7 m. Find the rate at which energy is transferred by conduction from the surface to the bottom of the pond
what is the approximate market value of the bond : A 15 year zero coupon bond was issued with $1000 par value to yield 8%. What is the approximate market value of the bond?
How much must bob saveper year during the next 20 years : TSP Financial has advised Bob that he can safely assume that all savings will earn 12% per annum until he reitres. but only 8% thereafter. How much must Bob saveper year during the next 20 years preceding retirement? Show all work/calculations.
What is power level at output of receive antenna terminals : A receive antenna located at 1km from the transmitter has a gain of 5dBi. Assume that there are 2dB of system loss.A. If the system operates at 900MHz, what is the power level at the output of the receive antenna terminals

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Develop a control system to fill a container with water

Develop a control system to fill a container with water after it is emptied through a stopcock at the bottom. The system must automatically shut off the water when the container is filled.

  Calculate most positive and most negative values for output

For , R1 = 1000 -ohm, R2 = 500 -ohm,R3 = 5000 -ohm, and RL = 2000 -ohm. The source is sinusoidal, vi (t) =120 cos(2-ohm60 t). Using the piece-wise linear model for the diode

  Calculate the power in each resistor

If R2 = 2R1, R3 = 3R1 and the total power taken by the circuit is 480 watts. Calculate the power in each resistor

  Find the norton equivalent current for the circuit

A somewhat discharged automotive battery has an open-curcuit voltage of 12.5 V and supplies 50 A when a 0.1 ohm resistance is connected across the battery terminals. find the thevenin equivalent voltage

  Draw circuit that implements parallel bit-slice parity check

Draw circuit that implements parallel bit-slice parity checker. Its input is X=xn-1xn-2...x1x0 and it should produce output F=1 iff input X has even parity. Make sure to label all signals and ports.

  Give signal multiplied by a periodic rectangular pulse train

A aperiodic signal x(t) = 2sinc(2t) is multiplied by a periodic rectangular pulse train s(t) with fundamental frequency F0 = 4 Hz and the fundamental rectangular pulse given by p(t) = 1, -1/80

  How much stator referred external resistance per phase

How much stator referred „external? resistance per phase should be connected in the rotor

  Determine what is the potential of the body now

A body attached to earth ground by an electrical conductor is at zero electrical potential. A charge of 25 C is added to the body. What is the potential of the body now. Explain.

  Calculate the free space loss-received power and fade margin

Perform a link budget for a 25-kilometer point-to-point microwave link in the 30 GHz band. Calculate the free space loss (dB), received power dBm), fade margin (dB), and Fresnel zone radius(m) given the following: Tx Power = 70 dBm

  Determine the initial x and final value x

Determine the initial x(0+) and final value x(infinity), given the following Laplace transforms X(s): X(s) = 2s2 + 5/s3 + 3s + 1

  Compute the fourier transform of the given signals

compute the fourier transform of the following signals, using the symbolic manipulator to perform the integrations. Plot the signal x(t) and the magnitude |X(&)| of the fourier transform a) x(t) =2e ^ (-4t) cos (10t) u(t)

  Find quantized output for each of sample values of signals

Two Bit Analog to Digital Converter - MATLAB Let x (t) = 0.8 cos(2*pi*t) + 0.15, 0≤ t ≤ 1, and zero otherwise, be the input to a two bit ADC converter. a.) For a sampling period Ts = 0.025 sec; determine and plot using MATLAB the sampled signal: x (n..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd