Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 300 ohms resistor is connected across the 300 ohms antenna input of a television receiver. The bandwidth of the receiver is 6 MHz, and the resistor is at room temperature (20 degrees C). Find the noise power and noise voltage applied to the receiver input.
b unit vector a θ dotted with unit vector a y (dotted means dot product) θ is from spherecial coordinates and starts from the postive z direction c unit vector a r crossed with unit vector a x (crossed means cross product).
Create the layout design for MOS inverter using a depletion-type transistor with VTL = -0.3V and an enhancement-type device with VTO = 0.5V such that tPLH is less than or equal to 15ns and tPHL is less than or equal to 1ns with CL = 1pF.
Taking under consideration a microcontroller, such as the 68HC12, identify five internal subsections within your selected microcontroller and provide an explanation for each subsection's function.
Twenty voice signals are to be multiplexed and transmitted over twisted pair. What is the bandwidth required (in bps) if synchronous time division multiplexing is used
Carlos runs with velocity v=(5.0 m/s, 25 degrees north of east) for 10 min. How far north of his starting position does Carlos finish
A group of technicians is gathered around a circuit that works with one signal generator but nit with the other. No one can figure out why one generator works but not the other. What might be happening.
Consider a causal LTI (Linear-time invariant) system described by the following differential equation: \(\frac{d^2}{dt^2}y(t) + 5\frac{d}{dt}y(t) + 6y(t) = \frac{d}{dt}x(t) + x(t)\) a) Determine the transfer function of this system.
Frequently, the output of transducers are much smaller than what an A/D converter expects on its input. That would require an amplifier to match it. Sometimes the output does not start at 0V. Usually the minimum reference input voltage of an A/D
assume filter is connected to a pure resistive load. The cutoff frequency is not to drop below 25krad/s. What is the smallest load resistor that can be connected across the output terminals of the filter.
A constant electric field, E=12 V/cm, exists in the +x direction of an n-type gallium arsenide semiconductor for . The total current density is constant and is equal to 100 A/cm2. At x=0, the drift and diffusion current densities are equal.
Consider a system equation s^4 + s^3 + s^2 + 2s + 10 = 0. FInd out its Routh Table. Determine if this system is stable, marginal stable or unstable. How many roots are stable and how many roots are unstable.
Data at a rate of 2 Mbps is to be transmitted via a pass-band communication system whose carrier frequency is 500MHz. A binary antipodal system with roll-off factor of 0.2 is used for this communication.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd