Find leakage resistance on the primary and secondary sides

Assignment Help Electrical Engineering
Reference no: EM13279302

A set of open circuit test and short circuit test have been performed on a transformer. A supply voltage of 480 V is applied to the primary side of the transformer and the following data is obtained for the open circuit test.

Poc 720 W
Voc 240 V
Io 9.7 A

Then, the following set of data is taken for a short circuit test.

Psc 750 W
Vsc 37.2 V
Isc 51.9 A

Later, the high side of the transformer is connected to a multi-meter with the low side left open. The meter registers a reading of 0.11 ohm. Afterwards, the multi-meter is connected to the low side with the high side left open. The meter registers a reading of 0.029 ohm.

It is generally assumed that for this 2:1 transformer that the reactance at both sides contributes equally to the equivalent reactance of the transformer.

The resistance readings collected after the open and short circuit tests are the resistance reading when the transformer is operating with DC. Supposedly, the resistance collected should be the same as the leakage resistance, distributed with the same ratio on the primary and secondary side of the transformer. However, this is not always true. Due to certain unknown factors, the leakage resistance deduced from short circuit test is higher than the value obtained with DC source.

Find out the following:
1. The leakage resistance on the primary and secondary sides
2. The leakage reactance on the primary and secondary sides
3. Is the leakage resistance higher than the value obtained with DC source? Why

Reference no: EM13279302

Questions Cloud

The radius of a star-surface temperature : The radius of a star that has a surface temperature of 28900k and is 10000 ties brighter than the sun is___Rsun? I was told that the answer is 4.027 Rsun but im not sure how to get the answer
Determine the weight of the truck : A small ferryboat is 4.00 m wide and 6.00 m long. When a loaded truck pulls onto it, What is the weight of the truck
Evaluate the number of gold atoms in a unit cell : Gold has cubic crystals whose unit cell has an edge length of 407.9 pm. The density of the metal is 19.3 g/cm3. Calculate the number of gold atoms in a unit cell. What type of cubi lattice does gold have
Which machine should bruno purchase and why : Whichever machine is purchased will be replaced at the end of its useful life. Which machine should Bruno's purchase and why?
Find leakage resistance on the primary and secondary sides : The resistance readings collected after the open and short circuit tests are the resistance reading when the transformer is operating with DC. Supposedly, the resistance collected should be the same as the leakage resistance, distributed with the ..
Explain how many grams of h2so4 are required : If 20.g of NaCl are used, how many grams of H2SO4 are required for complete reaction? Using the balance equation 2NaCl(s)+ 1H2SO4(aq)= 2HCl(aq)+ 1Na2SO4
From what height was the ball thrown : A ball is thrown from a window with Vo=2m.s at an angle of 53 degrees ABOVE the horizontal. From what height was the ball thrown
Explain an aqueous solution of phosphoric acid : Write a balanced (a) molecular, (b) overall ionic, and (c) net ionic equation for the reaction between an aqueous solution of phosphoric acid, H3PO4 (aq) , and an aqueous solution of sodium hydroxide. The products are sodium phosphate and water
Calculate the standard deviation of returns : The average variance of the annual returns for a typical stock is 1500 and its average covariance with other stocks is 400. Based on this information.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Lithium ion battery technology

The paper includes Lithium ion battery technology with its advantages and disadvantages. The paper discusses about the Lithium air battery in which detailed reactions of Lithium with air including nonaqueous as well as aqueous are given.

  Power transformers and tariffs

Construction of different types of power transformer, significant energy savings

  Paper on orthogonal frequency-division multiplexing

This document is shown a paper on Orthogonal frequency-division multiplexing with advantages, disadvantages and uses.

  Function of the hmi in a scada system

This assignment contains electronics engineering questions like State the commonly found components of a SCADA (Supervisory control and data acquisition) system. and decribe the function of the HMI in a SCADA system.

  Resultant waveform of the odd harmonic series

Prepare an Excel graph showing the individual components and summated resultant waveform of the odd harmonic series resulting in an approximate square wave.

  Explain scada system

Explain the function of the HMI in a SCADA system.

  Design a 2-digit 24 second shot-clock

Design a 2-digit 24 second "shot-clock" countdown timer with pushbutton controller.

  Model a discrete-time system

To understand di erent signal models To be able to model a discrete-time system and design simple signal processing algorithms.

  Draw a relay construction diagram

Draw a relay construction diagram and briefly explain the operation of a relay.

  Frequency division multiplexing

Write a short technical report on Frequency Division Multiplexing

  Impact of electron energy

Briefly discuss the impact of electron energy, electron current and target on the Bremsstrahlung generated.

  Traffic light controller

The schematic of the traffic light controller

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd