Find laplace transform of function nd time-shifting property

Assignment Help Electrical Engineering
Reference no: EM13282345

Find the laplace transform of the following functions and the time-shifting property (if needed) of the unilateral Laplacetransform:
 u(t)-u(t-1)

Reference no: EM13282345

Questions Cloud

Find out the molecular orbital theory diagrams associated : Can someone explain to me how you would determine the molecular orbital theory diagrams associated with butene and overall the basic concept behind molecular orbital theory and drawing diagrams associated with it
How much power will actually be at the antenna feed point : A 200 foot transmission line that has a loss of 6db per 100ft has 100 watts inserted from a transmitter at 4 MHz . How much power will actually be at the antenna feed point.
Determine the electric field intensity everywhere : Two infinitely long coaxial cylindrical surfaces, r = a and r= b (b > a), carry surface charge densities ρsa and ρsb,respectively. (a) Determine the electric field intensity everywhere.
Evaluate the volume of the tank if the total pressure : Compute the volume of the tank if the total pressure of the mixture is 44.08 psi at 86°F. What is the partial pressure of each constituent and the average molecular weight of the mixture
Find laplace transform of function nd time-shifting property : Find the laplace transform of the following functions and the time-shifting property (if needed) of the unilateral Laplacetransform:  u(t)-u(t-1)
Find the ratio of the diameter to the thickness : As you eat your way through a bag of chocolate chip cookies, you observe that each cookie is a circular disk with a diameter of 8.50 ± 0.02 \rm cm, Find the ratio of the diameter to the thickness
Estimate the temperature at the iron-cork boundary : A replace poker consists of a wrought iron rod, 50 cm long and 5 cm2 in cross-section, fused to a piece of cork 10 cm long, Estimate the temperature at the iron-cork boundary
Find the total chargeq that is contained in a circular disk : The surface charge density throughout the z = 0 plane isρs = 1/ρ[C/m2],where ρ is specified in meters. Find the total chargeQ that is contained in a circular disk of radius 1.0[m]that is centered about the origin in the same plane.
What is the least amount of force you must exert : A bolt is to be tightened with a torque of 8.0 Nm. what is the least amount of force you must exert

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain what change in the sound do expect to hear

if you use the sinusoidal waveform to drive the speaker: What change in the sound do you expect to hear when you increase the amplitude of the sinusoidal signal on the function generator

  Find magnitude of electric field intensity on inner comductr

A long cable with cylindrical cross-section has inner conductor of radius a and an outer conductor of inner radius b and outer radius c. The dielectric constant of the material between the conductors is 3.

  How many ram and rom chips are needed to employ ram chips

A computer employs RAM chips of 256 x 8and ROM chips of 1024 x 8. The computer system needs 2K bytes of RAM, 4K bytes of ROM, and four interface units, each with four registers. A memory-mapped I/0 configuration is used.

  Design a simple pnp current source for output current

(a) Design a simple PNP current source to give an output current of IO = 0.5 mA (nominal value). The transistor parameters are f = 50, VEE = 10 V, VCC = 10V, |VBE| = 0.7 V, |VCEsat| = 0.3 V and VA = 50 V (for all transistors)

  Implement carry-out and sum functions for 1-bit full adder

Implement the carry-out and sum functions for a 1-bit full adder using a 3-to-8 decoder block with active-low outputs and additional gates (what gate types should be used). Complete the truth table and draw the circuit diagram

  Determine the impedance of the quarter wave line

A 50 ohms lossless transmission line is to be connected to a load of 25 ohm. Use a lamda/4(quarterLamda) length of line of unknown impedance between the load and the 50-ohm line to match it,

  Explain absorption loss of metal shielding

Absorption loss of metal shielding, A plane metal shield offers an absorption loss of 30 dB at a frequency of 10 kHz to normally incident radiated emission.

  Identify processing needed to convert inputs to outputs

Identify three test cases, one using a positive number, and one using a negative number, and one using incorrect input (ie. Input a letter rather than a digit for the numeric input). For each of the three test cases show what inputs you will use a..

  Determine the resistivity of gold at the temperature

A gold wire (resistivity of 2.44× 10(-8) Ω·m and a temperature coefficient of 3.4×10(-3) °C-1) with a radius of 0.100 mm has a uniform electric field of 2.50 V/m imposed along its entire length. The temperature of the wire is 50.0°C.

  Determine the poles and zeros of the filter

Design a filter for a biomedical instrument to eliminate DC (f = 0), 500 Hz tone, and its corresponding harmonics. The system sampling rate is 2,000 Hz. Place all the required poles at the origin to obtain a FIR filter.

  Determine secondary voltage and the secondary current

An autotransformer with a total of 600 turns has its secondary winding embracing 200 turns. The 600 turns are connectred to a 60Hz, 2400V driving voltage. A load connected to the secondary draws 4.8kVA at 0.6 power factor lagging.

  Determine the percentage speed regulation

A 120 V separately excited DC Motor is operated at a fixed field current. It has an armature resistance Ra = 10 ohms, and a machine constant K = 0.1 V/rpm. The armature current is 0.5 amps with no load, and 3.0 amps at full load.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd