Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Find electric field everywhere produced by two concentrically oriented spheres of radii Ra and Rb (Rb > Ra ) whose volumes are uniformly and oppositely charged to the same amount of charge, Q0.
A three-phase synchronous generator (Delta-connected) rated at 10KVA, 230 V, has a synchronous reactance of 1.2ohms per phase and an armature resistance of 0.5ohms per phase. (a) Draw the phasor diagram.
The frequency response of an FIR filter is H(ejw)=b0+b1*e^-jw+b2*e^-2jw. In each case below, state whether the filter is highpass, lowpass, bandpass or band stop and draw the pole zero plot.
A window is etched through a 500 nm thick oxide on a [100] silicon wafer. The wafer is re-oxidized at 1100 °C using wet oxidation to grow a 750 nm thick film inside the window. Draw a cross-section of the wafer following the second oxidation.
A 52-kg pole vaulter running at 12 m/s vaults over the bar. Her speed when she is above the bar is 0.7 m/s. Neglect air resistance, as well as any energy absorbed by the pole, and determine her altitude as she crosses the bar.
Once INIT is negated, Z should remain 0 until X has been 0 for two successive ticks and 1 for two successive ticks, regardless of the order of occurrence. Then Z should go to 1 and remain 1 until INIT is asserted again.
A 2.4KV, single-phase circuit suppllies a load of 250KW at a lagging power factor, and the load current is 160A. If it is necessary to improve the power factor, determine the following: (a)The uncorrected poer factor and reactive load.
A 460-V, four-pole, 75-hp, 60-Hz, Y connected, three phase induction motor develops its full load induced torque at 1.2 percent slip when operating at 60 Hz and 460 V. Find Tmax, Smax and rotor at maximum torque for this motor.
What is the (approximate) maximum electric field intensity for which constant mobility may be assumed for electrons in silicon. In a digital circuit with a supply voltage of 1V, what is the corresponding gate length for MOS transistors.
Instead of recreating the design every time we change the instruction ROM, we want to have a way to change the instructions while the system is running. Discuss how the UART can be used to fill an instruction RAM instead
The input, Vin, is differential not single-ended. Design an analog circuit with a transfer function of Vout = 50 Vin + 2.5 powered by a single +5 V supply. You may use any of the analog chips.
Discrete sequence plot in Matlab, Consider the following formula, x[n] = x[n-1] + x[n-3] n>=3, find the rest of the sequence for 0
If we have a 600ohm transmission line terminated with a 1200ohm resistor, how long must the transmission line be if the input impedance is purely real?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd