Find dimension of window after ideal isotropic etching

Assignment Help Electrical Engineering

Reference no: EM13268686

A set of 4 µm wide windows are to be etched into a SiO2 film of thickness 0.8µm.

a) Find the dimension of the window, as measured at the top of the oxide, after ideal isotropic etching (i.e. no overetch). Draw a cross section of the window opening with the resist still on.

b) What is the dimension of the window at the oxide substrate interface.

c) Find the average slope of the window edge.

d) Repeat the above question a), b) and c) if the process was done with a 20% over-etch, assuming that the silicon is etched at 2% of the oxide etch.

e) what type of Si wafer (orientation) and chemical etchant would be needed to make a perfectly vertical wet etch for these 4 µm wide windows? Comment on the practicality of such an etch

Reference no: EM13268686

Questions Cloud

Calculate the phase impedance of the transformer in per unit : A 50-KVA, 13,800/208 V ?-Y distribution transformer has an equivalent phase impedance 114.2+j800 ohm referred to the high voltage side. Take the rated voltage as the base voltage and the rated VA as the based voltampere value.

Determine the angular size of the moon : the moon has an angular size of .5degrees when viewed with unaided vision from earth. what is the angular size of the moon as seen through this telescope

Draw appropriate control scheme using simplified isa symbols : Wastewater leaving the ACME cheese factory must be neutralized to a pH between 6.8 and 7.2. Citric acid is available to decrease pH and sodium hydroxide is used to increase pH.

Predict the effect of doubling the reactant concentration : In any chemical fabrication process (eg. wet etching or CVD) there are two main regions where the reaction rate is dominated by different processes. Name them and explain what each of those regions mean.

Find dimension of window after ideal isotropic etching : A set of 4 µm wide windows are to be etched into a SiO2 film of thickness 0.8µm. a) Find the dimension of the window, as measured at the top of the oxide, after ideal isotropic etching (i.e. no overetch).

Discussion post excluding formal citation : What are the merits of each argument and which side do you support and why? How does the use of capital punishment in Texas compare to other states?

Find n that probability of detecting at least one defective : From a large lot of new tires, n tires are to be sampled by a potential buyer, and the number of defectives X is to be observed. If at least one defective is observed in the sample of n tires, the entire lot is to be rejected by the potential buye..

Determine the value of the constant c are valid : Determine the value of the constant c such that the following functions are valid probability functions: A. p(x) = cx/20, x = 1,2,3,4,5,6 and zero elswhere. B. p(x) = c(X^2 + 1), x = 1,2,3,4,5, and zero elsewhere.

What is the potential of the outer shell : Two, concentric, thin spherical shells of radii R1 = 31.3 cm and R2 = 39.1 cm are uniformly charged with a total charge Q1 = -56.5 ?C, What is the potential of the outer shell

User Account

All Pages