Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Given the function f(X1, X2, X3, X4) = fm(0,1,4,6,911,14,15). Implement the function f using a 4:1 multiplexer. Assume that inputs are available in both forms: complemented and non-complemented. Use only the multiplexer. Hint: move the function to K-map and try the possible combinations for the select inputs.
Suppose a generator is going to be connected to a big network. Why should the frequency of this generator be slightly higher than the frequency of the system.
What is the capacitance ratio for the capacitors with Ta2O5 and oxide/nitride/oxide dielectrics for the same thickness, provided the oxide/nitride/oxide has thickness ratio 1:1:1 for the oxide to the nitride
The penalty for main memory access is 100 clock periods for both data and instructions. The probability of an instruction cache miss is 2%. The probability of a data cache read miss is 5%. The data cache has a write-back
Voltage regulator utilizes a 500 mW Zener diode with Vz=6.7V at 20mA, rz=lOohm and IzK=5mA. The supply voltage y+ has a nominal value of 12V but can vary by ± 1 V. The load resistor is fixed at 330ohm
Determine the relative permittivity of the dielectric, the maximum and minimum electric field intensities in medium 1 and the electric field intensity in medium 2.
The resistance of the field circuit of a shunt-excited dc generator is 200. When the output power of the generator is 100kW, the terminal voltage is 500V and the generated e.m.f is 525V.
why does the instruction set include an INC (DEC) instruction to increment (decrement) a memory byte when the same function could be accomplishe using an ADD (SUB) instruction
Assume the system shown in the Fig. is balanced, Rw = 0, Van = 208 angle 0 degree V, and positive phase sequence applies. calculate all phase and line currents, and all phase and line voltages, if Zp is equal to a) 1K ohms b) 100 + j48 ohm
What is the highest frequency of a triangle wave of 20V peak-to-peak amplitude that can be reproduced by an op amp whose slew rate is 10v/s. For a sine wave of the same frequency.
What is the modulus of this counter. How does this relate to the clock frequency division that this counter can provide. At what number does this counter reset to start the sequence over again.
The amplifier is connected to the handset antenna which has an impedance of 35 + j10 at one unspecified operating frequency. Find the inductive reactance and capacitive reactance needed to match the transmitter output to the antenna
Assume that you have two DC voltage sources of 1.5 volts each (like two AA batteries). The positive terminals are wired together (joined together) and the negative terminals are labeled A and B respectively.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd