Find amount of electrical energy exdpended in raising temp

Assignment Help Electrical Engineering
Reference no: EM13278686

Find the amount of electrical energy exdpended in raising the temperature of 45 litres of water by 75°C. To what height could a weight of 5 tonnes be raised with the expenditure of the same energy? Assume efficiencies of the heating equipment and lifting equipment to be 90%
and 70% respectively.

Reference no: EM13278686

Questions Cloud

Find the force that the left cable exerts on the board : Ray decides to paint the outside of his uncle's house. He uses a 4.0-m-long board supported by cables at each end to paint the second floor. find the force that the left cable exerts on the board
Calculate the volume of water used when delivering a load : An hydro-electric station has a turbine of efficiency 86% and a generator of efficiency 92%. The effecitive head of water is 150 m. Calculate the volume of water used when delivering a load of 40 MWfor 6 hours. Water weighs /000 kglm3.
What positions you need to take in each of the options : What positions you need to take in each of the options to create a bullish call spread? Bearish call spread? Describe the payoffs at various stock prices with a set of equations or table, for each strategy. Show all work.
What should be the hedge ratio : Verify your answer using the risk-neutral approach-do not just say that you have the same answer; you will need to show the work that the two approaches give the same answer.
Find amount of electrical energy exdpended in raising temp : Find the amount of electrical energy exdpended in raising the temperature of 45 litres of water by 75°C. To what height could a weight of 5 tonnes be raised with the expenditure of the same energy.
Calculate the dollar cost of each of the proposed plans : If the firm had made a purchase of $100,000 for which it had been given terms of 2/10 net 30, would it increase the firm's profitability to give up the discount and not borrow as recommended in part b? Why or why not?
What value resistor should be used to generate the heat : A 22.5 ohm resistor is connected across a 15 V battery. What value resistor should be used to generate the same amount of heat if the power source is 283 Vp-p at 60 Hz
Determine the price and number of shares outstanding of each : Determine the price and number of shares outstanding of each stock at the beginning of Week 1 (time t), and also at the end of Week 4 (time t+1). It may help to put this data in a table like this.
How much charge flows past a point in the wire : A wire loop that encloses an area of 10 cm2 has a resistance of 5 Ohms. How much charge flows past a point in the wire

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Develop a functional design for a system that measures speed

Develop a functional design for a system that measures and displays the speed of a bicycle. Be sure to clearly identify the design levels, function requirements, and theory of operation for each level.

  Explain binary symmetric channel

Binary symmetric channel, Assume that we are transmitting binary digits over a binary symmetric channel. Let p(x=0)=p(x=1)=0.5.

  Find values of external resistors for astable multivibrator

determine the values of the external resistors for a 555 timer used as an astable multivibrator with an output frequency of 2 kHz, if the external capacitor C is 3.0 mf and the duty cycle is to be approximately 75%

  Determine the bus voltages at midnight

Draw the positive, negative, and zero sequence networks for the system. Include all impedance values and determine the bus voltages at midnight? What problem(s) do you detect?

  Determine the gain of the antenna in db

One of the home satellite services uses a dish antenna having a diameter of 18" (0.457 m) and frequency of 12.45 GHz. If the illumination efficiency is 70%, determine the gain of the antenna in dB

  Would you please show me how to develop and s-r latch

Develop S-R Latch using 74x74, Would you please show me how to develop and S-R latch using a single 74x74 positive-edge-triggered

  Determine the minimum required sampling rate

(a) Determine the minimum required sampling rate fsamp(min). Hence, use twice this value. (b) Draw a block diagram of the system indicating the requirements of each block. (c) Design and write the difference equations of the digital filters needed.

  Find change in capacitance for diode with cross-section area

what is the change in capacitance for a diode with cross-sectional area of 0.01cm^2, dielectric constant of 11.8 when a change in the applied voltage gives a depletion distance change from 1/2 micrometer to 1 micrometer

  What is the value of the smallest resistor

The voltage drops across three resistors in series are measured 10V, 15V, and 25V. If the largest resistor is 47 ohms, what is the value of the smallest resistor?

  Compute the speed of a three phase motor

A three phase Y-connected 220-Volt 10-Hp, 60Hz, 6-pole induction motor has the following constants in Ohms per phase referred to the stator. R1=0.294, R2=0.144, X1=0.503, X2=0.209, Xm=13.25.

  For visible light in water what is the range of wavelengths

Visible light has wavelengths from 400 to 700 nm in a vacuum. a. What is the range of frequencies b. For visible light in water, what is the range of wavelengths

  Find position of fermi level with respect to ei in si

Given: Si is doped with boron atoms; concentration of boron atoms is 1014 cm-3.  Find: carrier concentration in Si at T = 300 K. (Hint: use Principle of Space Charge Neutrality)  Find: Ei - position of Fermi level in intrinsic Si at T..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd