Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
An infinitely long line charge (Pl= 21 PI nC/m) lies along the Z-axis. An infinte area sheet charge PS= 3nC/m^2 lies in the X-Z plane at a distance Y =10 m.
a) Using Gauss' law find the field E due to the line charge.
b) Using Gauss' law find the field E due to the infinite sheet charge.
c) Find a point on the Y-axis where the net E field is zero.
a plane wave is obliquely incident onto the planar interface between mismatched, lossless, nonmagnetic, uniform media, yet undergoes no reflection. If incidence is at 54 degrees to the normal, at what angle to the normal does the transmitted wave ..
Using the table, what is the byte stored at address 2F? Using the table, what is the byte stored at address 33?
The total charge that has accumulated on the positive plate of a capacitor varies with time. The charge follows q=At^2 for the first 4s. a) Find the value of current at t=2,6,9,12,16 s. b) Sketch the current i(t) as a function of time
Problem Statement: Solve the load flow problem below in Matlab, or similar program, using the Gauss-Seidel Method.
Note that after a collision, the expected numbers are slightly different in two systems, but the difference is unimportant since collisions are rare.
"Divide by 3 clock with 50% duty cycle" is the most commonly asked ASIC design question. This solution gives a simple design in which only 1 counter is required which works only on positive edge of the clock.
A temperature sensor has a static transfer function of 0.15 mV/C° and a time constant of 3.3 s. If a step change of 22° to 50° C is applied at t=0, find the output voltage at 0.5 s from t=0s to t=10s
Calculate the percentage second harmonic distortion present in the output. Calculate the percentage error in the output voltage compared to its ideal value at the instant of time when t= 1/3200 seconds.
A waveform generator is connected to an op-amp which has been setup as a voltage follower. The voltage follower is then loaded with a 50 Ohm resistor. What output impedance setting should the waveform generator use
Output levels of higher order products of a linear amplifier, If a tone is put into an amplifier, and its amplitude is increased by 1 dB, how much will the amplitude of the third-order products increase in dB?
Identify the types of system-building methods used by Dorfman to build its wireless warehouse system.
How tall must the antennas be if the link operates on a frequency of 2.450Ghz, D1=5miles, D2=11miles, and the obstruction is 60 feet high?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd