Find a minimum two level circuit using and gate

Assignment Help Electrical Engineering
Reference no: EM13229571

Find a minimum two level circuit (corresponding to the sum of products expressions) using AND and one OR gate per function for each of the following sets of functions:

f(a,b,c,d) =?m(1,3,5,8,9,10,13,14)

g(a,b,c,d) =?m(4,5,6,7,10,13,14)

Reference no: EM13229571

Questions Cloud

Determine magnetic flux density using mean radius of toroid : Assume the coil around the toroid is one single coil and extends all the way around. A toroid is like a donut with a circular cross section. The following characteristics are given: Toroid material = sheet steel, N = 250 turns Inner Radius
State the percentage of an additive in gasoline was measured : The percentage of an additive in gasoline was measured six times with the following results: 0.14, 0.15, 0.16, 0.17, 0.20, 0.11%. Find the average and RSD and 90% confidence intervals for the percentage of the additive.
What value of resistors are required for the voltage divider : A HCS12 ATD is set to 8-bit unsigned mode. A temperature sensor measuring 0 to 100 degrees with an output of 25 mV/degree is attached to the input. The ATD low voltage reference is attached to ground and the high voltage reference
Describe target markets of each branded supermarket : Draw the layout of each store and if possible include photographs-make sure you indicate the brand on the diagram
Find a minimum two level circuit using and gate : Find a minimum two level circuit (corresponding to the sum of products expressions) using AND and one OR gate per function for each of the following sets of functions: f(a,b,c,d) =fm(1,3,5,8,9,10,13,14) g(a,b,c,d) =fm(4,5,6,7,10,13,14)
Explain the ratio of the number of atoms of the isotopes : The ratio of the number of atoms of the isotopes 69Ga and 71Ga in eight samples from different sources was measured in an effort to understand differences in reported values of the atomic mass of gallium
Determine change in resistance when the temperature rises : A platinum resistance coil has a resistance at O0 C of 100 . Determine the change in resistance that will occur when the temperature rises to 30°C if the temperature coefficient of resistance is 0.0039 K-1.
Explain what would be the concentration of each of the ions : NaCl is added to 33.4ml of 0,327M AgNO3(silver nitrate). What would be the concentration of each of the ions(ie Ag+, NO3- Na+ and Cl-) in the reaction mixture after the reaction.
Demonstrate positive leadership skills : Identify and apply appropriate theory and models of leadership and have developed self-awareness of their own personal attributes relevant to leadership.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Derive the peak voltage imposed on the transistor q

1) For a forwarard converter, derive the minimum value of Vr - as a function of the input voltage Vg, the duty cycle D, and the turns ratio N1/N2 - that will cause the transformer magnetizing current to be reset to zero by the end of the switching..

  Design a voltage-divider network to supply the load

The voltage across the load must remain between 4.7 and 5.0 V for all values of load current. Design a voltage-divider network to supply the load. You may assume that resistors of any value desired are available.

  Using the nth order term only of the transfer polynomial

Using the Nth order term only of the transfer polynomial, find the Nth order relationship for the Nth order products.

  What is a relative addressing mode

Discuss different types of addressing modes of HCS12. What is a relative addressing mode What is the difference between a direct and an extended addressing mode Discuss how Registers X and Y are used in index addressing mode.

  Write canonical product-of-sum expression for f in shorthand

Consider the function f which has four inputs a,b,c,d and one output such that the output is a 1 if and only if the number of 1s in the inputs is even. (a) Write the canonical product-of-sums expression for f. Do not use the shorthand notation

  Express the boolean function in sum of products

1. Express the Boolean function f(X,Y,Z) = XY  + X(Y + Z) in sum of products form showing the sum all nonzero minterms. 2. Express the Boolean function f(A,B,C,D) = A(B + BC) + ACD in sum of products form showing the sum all nonzero minterms.

  Determine the theoretical minimum sampling rate

A baseband signal has frequency components from 5 kHz to 15 kHz. Determine (a) the theoretical minimum sampling rate and (b) the maximum time interval between successive samples.

  Explain single phase circuit

Single Phase Circuit, A resistor and a capacitor are connected in series across a 150 V a.c supply. When the frequency is 40 Hz the current is 5 A

  Compute probability of having sum of 10 by throwing 2 dice

1. Compute the probability of having the sum of 10 by throwing (a) two dice, (b) three dice. 2. What is the probability of three of a kind for a poker hand with (a) a card deck of 52 cards, (b) a card deck of 32 cards

  What is statistical process control and quality control

Give five examples of things that are measured in semiconductor manufacturing to help maintain quality. Explain how a prober can give a false reading. How is sort different than E-test.

  Draw the sympol and truth table of the gate

draw the sympol and truth table of the gate that corresponds to the action of the logic gate.

  Determine closed-form expression of the cross-correlation

Compute and plot the correlation sequences r s1s2 (l), r s0s0 (l), r s1s0 (l) and r s2s0 (l) . Compute and plot the cross-correlation sequences and of the received signal with the template signals and s 2 (n).

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd