Fan mounted at the inlet of the electronic enclosure

Assignment Help Mechanical Engineering

Reference no: EM13708884

The electronic components of a computer are cooled by air flowing through a fan mounted at the inlet of the electronic enclosure. At steady state, air enters at 18 C, 1 atm. For noise control, the velocity of the entering air cannot exceed 0.9 m/s. For temperature control, the temperature of the air at the exit cannot exceed 34 C. The electronic components and fan receive, respectively, 68 W and 12 W of electric power. Determine the smallest fan area, in cm^2 , for which the limits on the entering air velocity and exit air temperature are met

Reference no: EM13708884

Questions Cloud

Separate stream of air with mass flow rate : Steam enters a counter flow heat exchanger operating at stead state at 0.07 MPa with a specific enthalpy of 2431.6 kJ/kg and exits at the same pressure as saturated liquid. The steam mass flow rate is 1.5 kh/min. A separate stream of air with mass fl..

Compression ratio and inlet pressure to give maximum imep : Design an SI engine operating on an four-stroke air-standard cycle using stoichiometric gasoline is to have a maximum cylinder pressure of 11,000 kPa at WOT. Inlet pressure can be 100 kPa without supercharging, or it can be as high as 150 kPa with a ..

Single tape turing machine : Double and Two Tape Turing machines - single tape Turing machine

Determine the velocity of the water at the inlet and exit : A pump is employed to deliver liquid water from a pond to a higher elevation. The pump steadily draws water from the pond at a volumetric flow rate of 192 gal/min through a pipe having a 7 in diameter inlet. The exit diameter of the pipe is 2 in. and..

Fan mounted at the inlet of the electronic enclosure : The electronic components of a computer are cooled by air flowing through a fan mounted at the inlet of the electronic enclosure. At steady state, air enters at 18 C, 1 atm. For noise control, the velocity of the entering air cannot exceed 0.9 m/s.

Volumetric flow rate-slip factor using stadolas equation : A centrifual pump is used to raise water against a static head of 18 m. The suction and delivery pipes, both .15m in diameter, have respectively, friction head losses amounting to 2.25 and 7.5 times dynamic head. The impeller, which rotates at 1450 r..

Determine the design point flow rate for the pump in gpm : A centrifugal water pump operates at 1750 rpm. The rotor geometry is shown in the sketch below. The inlet blade angle is 30 degrees and the exit blade angle is 90 degrees and the blade can be assumed to occupy negligible volume. Water enters with no ..

The compressor to compress the gas : A compressor is employed to compress gas flowing steadily through it . The gas enters the compressor at a temperature of 16°C, a pressure of 100 kPa, and with an enthalpy of 391.2 kJ/kg. The gas leaves the compressor at a temperature of 245°C, a pres..

Explain the control of the ignition process : Design an SI engine to operate on a six-stroke cycle. The first four strokes of the cycle are the same as a four-stroke Otto cycle. This is followed with an additional air-only intake stroke and an air-only exhaust stroke. Draw simple schematics, and..

User Account

All Pages