Express the approximate alkalinity of this water as mg

Assignment Help Civil Engineering
Reference no: EM13548152

1.A water sample has bucarbonate concentration of 220 mg/l ( HCO3- )and the PH of the water is 7.9 > Express the approximate alkalinityof this water as mg/l of CaCO3

2.What is the flow rate for a 12-inch diameter pipe with f = 0.028 for a 450-foot pipe that runs between two reservoirs that each have ends submerged under water? The intake end is square-edged and non-projecting. The difference in elevation between the two reservoirs is 150 feet. a).7.8 MGD b).13.3 MGD c).17.7 MGD d).23.8 MGD

Reference no: EM13548152

Questions Cloud

Compute the volume flow rate required to produce : Compute the volume flow rate required to produce a Reynolds number of 3.60 x 10 ^4. then, if the pipe is clean steel, compute several points of the velocity profile and plot the data.
At what depth would the vertical effective stress in a deep : At what depth would the vertical effective stress in a deep deposit of clay be 100 kpa, if e=1.1? The ground water level is a 1 m delow ground surface and S=95% above the groundwater level. Neglect pore air pressure.
Determine the allowable soil pressure for a maximum settle : A square footing 6ft by 6ft is to be installed 6ft below ground level on a sand stratum. Standard penetration tests were conducted on the construction site
Find the flow rate if the pump puts 22 hp in to the flow : A 110 f t long, 5 in in diameter (f = 0:033) connects two reservoir whose water surface elevations differ by 12 f t. Compute flow rate in pipe.
Express the approximate alkalinity of this water as mg : A water sample has bucarbonate concentration of 220 mg/l ( HCO3- )and the PH of the water is 7.9 > Express the approximate alkalinityof this water as mg/l of CaCO3
Find all contact forces : Cylinders A & B weigh 500N each and cylinder C weighs 1000N. Assuming frictionless contact between all surfaces, find all contact forces. Diameters A&B= 1, C=2
Calculated the change in vertical effective stress on the : A culvert is to be constructed in a bed of sand (e = 0.5) for drainage purposes. The foof of the culvert will be located 3 m below ground surface. Currently the groundwater level is at ground surface.
Find the z components of the electric field : An electron has an initial velocity with an x component of zero, a y component of 9.35 km/s, a z component 16.1 km/s, and a constant acceleration of 1.60 x 1012 m/s2 in the positive x direction in a region in which uniform
What is the probability that the maximum wind pressure will : A large parabolic antenna is designed against wind load. During a wind storm, the maximum wind-induced pressure on the antenna, P, is computed as P= 1/2CRV^2 Where C = drag coefficient, R = air mass density in slugs/ft3, V = maximum wind speed in ft/..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Commercial management in civil engineering 1-critically

commercial management in civil engineering 1-critically analyse the use of project related commercial risk registers

  Determine how many bits wide is the main memory data bus

A MIPS-based computer system with 2 GB of main memory that is built on a single circuit board. It is designed with a single control signal between the CPU chip and main memory, i.e. one bit of control that is set to one for Read operations

  Find dry unit weight-void ratio and degree of saturation

A soil specimen has a water content of 18% and a wet until weight of 118.5 lb/ft. The specific gravity of solids is found to be 2.72. Find the dry unit weight, void ratio, and degree of saturation.

  How should the guided bearings in piers of the curved region

In a curved prestressed bridge, how should the guided bearings in piers of the curved region be oriented with respect to the fixed bearing in abutment?

  Determine the minimum diameter a steel wire can have

If the elastic limit of steel is 5.0 10^8 Pa, determine the minimum diameter a steel wire can have if it is to support a 69-kg circus performer without its elastic limit being exceeded.

  Determine the new value of l if the flowrate stayed the same

When a channel of triangular cross section was new, a flowrate of Q caused the water to reach L = 2 m up the side of the channel. After considerable use, the walls of the channel became rougher and the Manning coefficient, n, doubled.

  How many liters per day of captured rain water are necessary

A paper mill releases 1 m^3/s of treated effluent at 75 C, which is mixed with captured rain water at 13 C before it is released to a nearby river. Regulations dictate that the effluent discharge cannot be over 20 C.

  What is min sight distance that should be provided on road

f the design speed of a multi-lane highway is 60 mph, what is the minimum sight distance that should be provided on the road if (a) the road is horizontal and (b) the road has a maximum grade of 5 percent

  Determine the angle theta as a function of delta t

At the reference temperature, three identical rods of length L form a pin jointed truss in the shape of an equilateral triangle, ABC. Determine the angle theta as a function of delta T, the temperature increase of the rod AB.

  What will be the ratio of mass of natural gas in the tank

At a given initial time, the pressure in thetank is 100 kPa gage, and the atmospheric pressure is 100 kPaabsolute. Some time later, after more gas is pumped into thetank, the pressure in the tank is 200 kPa gage, and the temp.

  Determine the time when the velocity is zero

The acceleration of a particle is defined by the relation a=-8m/s^2. Knowing that x=20m when t=4s and that x=4m when v=16m/s, determine (a) the time when the velocity is zero

  Compute the finals velocities v1 and v2 after collision

compute the finals velocities v1' and v2' after collision of the two cylinders which slide on the smooth horizontals shaft. The cofficient of restitution is e= 0.6. m1 = 2 kg, v1= 7m/s and m2 = 3 kg , v2 = 5 m/s

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd