Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
give three methods that are used to express logic relationship between inputs and outputs of a logic gate, for example a three-inputs NOR gate.
A 10 kHz signal modulates a 500 MHz carrier, with a modulation index of 2. What are the maximum and minimum values for the instantaneous frequency of the modulated signal
What is the quantization signal to noise ratio SNRQ at the receiver output? e. If the SNRQ were to be raised to 96 dB, how many bits would the ADC and DAC need? What would be the bit rate on the serial link?
The steady-state electron distribution in silicon can be approximated by a linear function of x. The maximum electron concentration occurs at x = 0 and is n(0) = 2.0 x 1016cm-3. At x = 0.012cm, the electron concentration is 5.0 x 1015cm-3.
2.25 kg of a fluid having a volume of 0.1 m^3 are contained in a cylinder at constant pressure of 7 bar. Heat energy is supplied to the fluid until the volume becomes 0.2 m^3. If the initial and final specific enthalpies of the fluid are 210 kj/kg..
Design a 3 th order high - pass Butterworth filter with a High Frequency gain of 20 DB and a cutoff frequency of 20 rad/s. 2) Using MATLAB, plot the frequency respon se of this filter, and the location of the filter poles.
In the plane z=5 there is a ring with a 3cm radius with its center on the z axis. The ring has a uniformly distributed charge Q. The origin 0,0,0 is at a small sphere with a mass of 0.5kg and a charge of -Q.
At the instant shown, car A has a speed of 20km/h, which isbeing increased at a rate of 300km/h2 as the car entersan expressway. At the same instant, car B is decelerating at250 km/h2 while traveling forward at 100 km/h.
A bar of p-type silicon, has a cross-sectional area A = 10-6 cm2 and a length L = 1.2 x 10-3 cm. For an applied voltage of 5V, a current of 2mA is required. What is the required (a) resistance, (b) resistivity, and (c) impurity doping concentratio..
Addition of two numbers in IEEE 754 format A) a=3f200000, b=be600000 B) a=3f200000, b=ff800000 C) a=01100000, b=80e00000
When unmodulated the carrier voltage is 75 volts peak. An information (modulating) signal of 15 KHZ with 5 volts peak amplitude causes a frequency deviation of 22.5 KHz. If the load resistor RL= 100 Ohms, determine the following Modulation index
Research coal deposits in the USA and US coal mine production. Approximately, what was the US annual production of coal from mines in recent years What was the coal production of the Appalachian or Eastern province
If we want to correct the power factor to 0.9 lagging, what is the value of Q we need to inject.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd