Explain what will be the average thickness of the film

Assignment Help Chemistry
Reference no: EM13267483

Oil Spreads on water to form extremely thin films. Assume o.2mm^3 of oil is allowed to spread on water over a surface area of 400 cm^2. What will be the average thickness of the film in Angstroms

Reference no: EM13267483

Questions Cloud

What is the acceleration of the crate relative to the ground : A crate of mass 45.0 kg is being transported on the flatbed of a pickup truck. What is the acceleration of the crate relative to the ground
Explain the final concentration of nadh be in the solution : Add 1mg of alcohol dehydrogenase. Assuming all of the ethanol is converted to acetaldehyde, what will the final concentration of NADH be in the solution
What is the value of the total circuit complex impedance : An input signal of 10V at 0o and a frequency of 1592 Hz is applied to a series RLC circuit with resistor R = 100 ohm, inductor L = 20 mH, and capacitor C = 250 nF. What is The value of the total circuit complex impedance.
Significance of plot in hanas suitcase or paperbag princess : Plot is the sequence of events showing characters in action. (103) discuss the significance of plot in hana's suitcase or the paperbag princess.
Explain what will be the average thickness of the film : Assume o.2mm^3 of oil is allowed to spread on water over a surface area of 400 cm^2. What will be the average thickness of the film in Angstroms
At what rate is heat being expelled by the engine : A certain automobile engine is performing work at the rate of 33900 W (45 hp) with an efficiency of 27%
What is the standard deviation of the returns : What is the standard deviation of the returns on a portfolio that is invested 52 percent in stock Q and 48 percent in stock R?
What are the majority and minority carrier concentrations : A silicon sample is 85x10^-6 m in length and has a cross-section of 20x10^-6 m x 6x10^-6 m. It has been uniformly doped with Arsenic with a doping density of 4.5x10^15 cm^-3. Assume the temperature is 300K and mobilities are u_n = 1300 cm^2/Vs and..
Find the force of the hammer : A 4 kg hammer is accelerated at 4m/s^2 before striking a nail for 1.6 sec find the force of the hammer

Reviews

Write a Review

Chemistry Questions & Answers

  How to find the ph of the resulting solution

Find the pH of the resulting solution when 20.00mL of a 0.1000M triethylamine (CH3CH2)3N (Kb = 5.2x10-4) solution is titrated with 20.05mL of a 0.1000M HCl solution.

  State the mass of an ice cube its initial tempature

The mass of an ice cube is 18.7 g, and its initial tempature is -14.4 degree C. The water resulting from the melted ice reaches the tempature of your skin,

  State the equation for the complete combustion of heptane

Write and balance the equation for the complete combustion of heptane, C7H16. You do not need to include any phase symbols or energy

  Define a main component of photochemical smog

a main component of photochemical smog. Classify this reaction as a synthesis, decomposition, single-displacement, or double-displacement reaction.

  What is the empirical formula of vanillin

When a sample of Vanillin weighing 2.500g burns in Oxygen, 5.79g of carbon dioxide and 1.18g of water is obtained. What is the empirical formula of Vanillin?

  What volume of o2 is required

What volume of O2 at 684 mmHg and 21 degree celsius is required to synthesize 25.0 mole of NO?

  Define what is the stoichiometric coefficient for oxygen gas

What is the stoichiometric coefficient for oxygen gas when the following reaction is balanced using the smallest whole number coefficients?C12H26(g) + O2(g) ? CO2(g) + H2O(g)

  Find what temperature in k is the reaction at equilibrium

Under certain condition for the reaction A ? B, ?H = 14.2 kJ and ?S = 27 J/K. At what temperature in K is the reaction at equilibrium?

  Define what is the minimum work required in methane

methane flowing at 2 mol/min is adiabatically compressed from 300 K and 1 bar to 10 bar. What is the minimum work required? Use Departure Functions.

  Define what is the flow rate of the gasoline and kerosene

What is the flow rate, m3, of the gasoline and kerosene stream coming off the first column? 2 - What is the composition of m7, the heating oil and lubricating oil stream coming off the second column?

  Compute the change in the entropy of the universe

calculate the change in the entropy of the universe between the time that the contents of the glass enter the lake and when thermal equilibrium is subsequently restored. State any approximations made in your calculation.

  What mole ratio of molecular chlorine to molecular oxygen

what mole ratio of molecular chlorine to molecular oxygen would result from the breakup of compound Cl2O7 into its constituent elements.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd