Explain what is the name of the standard unit cell

Assignment Help Electrical Engineering
Reference no: EM13229160

A 3-D cubic unit cell contains four atoms whose centers are positional halfway up along each of the vertical cell edges and one atom each centered in the middle of the top and bottom faces. Make a sketch of the unit cell. Use dots to represent the atom and include three parallel planes of atoms. What is the name of the standard unit cell used to characterize the lattice sketched?

Reference no: EM13229160

Questions Cloud

Explain 1-bromobutane and pentanoic acid : How could you convert butanoic acid into the following compounds? Write each step showing the reagents needed. (a) 1-Butanol (b) 1-Bromobutane and (c) Pentanoic acid
What is the corresponding pressure difference between points : Oil (density 0.91 g/cm^3) flows in a pipe (see fig.) and the flow rate is measured via a mercury manometer (density of Hg=13.546 g/cm^3). If the difference in height between the two legs of the manometer is 0.78 in.
Find out all equilibrium concentrations : Determine all equilibrium concentrations, the pH, the pOH and the percent ionization of each of the following acids in water.
How do you draw the line between gaming and cheating : Grades are partly intended to provide incentives for quality work. How do students strategically game grading systems in ways that might pervert this intent?
Explain what is the name of the standard unit cell : A 3-D cubic unit cell contains four atoms whose centers are positional halfway up along each of the vertical cell edges and one atom each centered in the middle of the top and bottom faces. Make a sketch of the unit cell.
Explain the concept of ethical fading : Can you think of a situation where you were so intent upon pleasing an authority figure, fitting in with your friends, or achieving a goal that you failed to give an ethical issue your full attention? Did that situation cause you regret?
Why does senior management often fail to realize the value : Why does senior management often fail to realize the value of human assets versus other organizational assets?
Explain the healthcare applications of chemical reactions : Discuss in detail the healthcare applications of chemical reactions. Which chemical reactions would you consider to be of importance to healthcare professionals? Why? In which situations are these chemical reactions useful to healthcare professiona..
Explain the alcohol ethyl alcohol or ethanol content : While questioning him, you learn that he consumed two bottles of beer at lunch. The alcohol (ethyl alcohol/ethanol) content in a 12 oz. bottle of beer is about 5%. The man's weight is 150 lbs and he was drinking over an hour period.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain memory storage and bit density

Memory storage and bit density, A hard disk contains four Platters. Each side of the platter is coated with a magnetic oxide, allowing data to be stored on it. The platters are 3.5 inches in diameter.

  Compute the maximum and minimum spectral frequencies

Compute the maximum and minimum spectral frequencies received by a mobile traveling at a speed of 100 Km/hr. What is the frequency of the received signal if the mobile is moving in a direction perpendicular to the direction of arrival of the trans..

  Presuming that ideal filters are available

Assuming that ideal filters are available, what is the lowest frequency at which the signal can be sampled and subsequently recovered in its analog form without distortion using a low pass filter?

  What is the differential output voltage

A differential amplifier stage has collector resistors of 5.1 Kohms each. If Ic1 = 1.35 mA and Ic2 = 1.29 mA, what is the differential output voltage.

  How many atoms are there in the unit cell

(a) How many atoms are there in the unit cell characterizing the Si lattice (b) Verify that there are 4.994 X 1022 atoms/cm' in the Si lattice at room temperature. (c) Determine the eenter-to-center distance between nearest neighbors in the Si lattic..

  What is the atomic polarizability of argon

Treat as an ideal gas ie it obeys pV=nRT law where pis pressure, V is volume, n is # of moles, R=82.056*10-6 m3-atm/mole-K is the universal gas constant and T is the absolute temperature.

  What is the maximum frequency that an input

An OpAMP has a unity gain frequency (ft) of 10MHz and a slew rate of 10V/us and AVoc = 120dB at DC (f=0).  Assume VCC = -VEE = 15 Volts.a. Approximate the cutoff frequency of the OPAMP itself. b.

  How the voice message is best received

You have a shortwave AM receiver (just an AM receiver that has the capability to receive signals in the FM frequency band) that receives an NBFM voice signal at some carrier frequency. You notice, however, that while the signal strength is maximiz..

  Compute the amount of time required to deliver

Compute the amount of time required to deliver 10 frames to the receiver with stop-and-wait flow control. Assume that all frames and ACKs are received correctly.

  Write an assembly-language program to add

Write an assembly-language program to add $40 to each element of list1 and store it to the corresponding element of list2. Use a loop. ORG $2000 LIST1 DC.W $21, $442, 3, 4, 5

  How long a 1 inch square bar of copper have resistance

Using coppers resistivity of 10.30 CM-olm/ft at +25 °C, find how long a 1 inch square bar of copper would need be to have a resistance of 1 at +20 °C

  What is the signal-to-noise ratio of the spread signal

Suppose that a voice signal normally occupies 30 kHz of bandwidth and has a signal-to-noise ratio of 20 dB. Spread-spectrum techniques are used to increase its bandwidth to 2 MHz. (a) What is the signal-to-noise ratio of the spread signal

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd