Explain what is no3- in the final aqueous solution

Assignment Help Chemistry
Reference no: EM13226678

The next items refer to the result of mixing 400. ml of 0.10 M NaOH and 100.0 mL of 0.10 M Mg(NO3)2. Reaction as shown goes essentially to completion.

2 OH- + Mg2+ ------->Mg(OH)2(s), K= Ksp^-1 = 1.8 x 10^11

a) What is [NO3-] in the final aqueous solution?

b) What [OH-] remains when the reaction is complete?

c) What is the small final [Mg+2]? Use the K above , or Ksp for Mg(OH)2 = 5.6x10^-12

Reference no: EM13226678

Questions Cloud

State what is the change in the measurement of the potential : What is the change in the measurement of the potential if a solution of 1.00x10-3 M NaF is exchanged for another solution of 1.00x10-4 M NaF?
Find out the value of the overall reaction : Determine the value of the overall reaction order in the rate law expression. Rate=k[A]^n [B]^m, from the following data.
What is initial value if the overhead values were considered : write an 8051 program that would generate a 200khz, 50% duty cycle, square wave at P1.0.Use Timer 0 for the delay. Ignore the overheads cycles due to the instructions in the loop. Assume 12 MHz clock. All data must be hex.
Determine the optimal production schedule for month : Set up the Transportation Table, model for this problem, use NW corner, Least cost, and Vogel methods to find the initial feasible solutions and what is the optimum solution
Explain what is no3- in the final aqueous solution : The next items refer to the result of mixing 400. ml of 0.10 M NaOH and 100.0 mL of 0.10 M Mg(NO3)2. Reaction as shown goes essentially to completion.
Determine the maximum torque occurs at starting : A three phase, 25-hp, 440-V, 60-Hz, 1750 rpm, wound-rotor induction motor has the following equivalent circuit parameters: R1=0.20 ohms, X1=1.0 ohms, R2=0.15 ohms, X2=0.8 ohms, Xm=30 ohms. The motor is connected to a three phase, 440-V, 60-Hz supply.
Compute percent yield of aspirin : You are given 2.72 g of salicylic acid. Using the procedure in the lab manual for the synthesis of aspirin, you recover 0.96 of aspirin. Calculate your percent yield of aspirin.
Calculate waveforms motoring in forward direction : Consider a permanent-magnet dc-motor with the following parameters: Ra=0.35Ohms, La=1.5mH, Ke=0.5V/(rad/s), Kt=0.5Nm/A, and Jm=0.02kgm^2. The rated torque is 4Nm. This motor is supplies by a switch-mode dc-dc converter
Define moles of strontium hydroxide are needed to react : Solid strontium hydroxide is added to a solution of nitric acid. How many moles of strontium hydroxide are needed to react completely with 500. mL of 0.40 M nitric acid?

Reviews

Write a Review

Chemistry Questions & Answers

  Electron configurations for c2 and f2

Write down the electron configurations for C2 and F2. What is the bond order for each? Which one is likely to have larger bond dissociation energy.

  Compute the ph of the solution at the equivalence point

Calculate the pH of the solution at the equivalence point. b) What volume of 0.05 M HCl solution should be added to the sodium glutamate solution to yield a pH of 4.5?

  Write net ionic equations for the reaction

Write a net Ionic equation for the reaction that takes place when aq barium chloride soln reacts with an aq soln of potassium phosphate.

  How many grams of nh3 can be produced from n2

3H2+N2=How many grams of NH3 can be produced from 3.91g of N2?

  How much limestone must be decomposed

How much limestone must be decomposed by heating to produce 250.0 grams of lime, CaO?assuming that the limestone contains 95.0% pure CaCO3.

  Explain what is mass percent of h2so4 in solution

What is mass percent (%w/w) of H2SO4 in this solution? (b) Would the mass percent (%w/w) of H2SO4 change with changes in temperature? Explain.

  Compute the mass of the sample of silver

energy to heat a certain sample of pure silver from 12.0 C to 18.2 C. Calculate the mass of the sample of silver.

  What is the final volume of the gas inside the cylinder

A cylinder, with a piston pressing down with a constant pressure, is filled with 1.90 mole of a gas (), and its volume is 40.0 liter (). If 0.400mole of gas leak out, and the pressure and temperature remain the same, what is the final volume of th..

  Is it realistic to disregard the presence of no

If the combustion gases consist of CO2, H2O, CO, O2, and N2 that exit at 1200 K and 2 atm, determine (a) the equilibrium composition of the product gases and (b) the rate of heat transfer from the combustion chamber. Is it realistic to disregard t..

  Define methyl salicyate

If you have .200 mL of methyl salicyate (density=1.184 g/mL)(molar mass=152.15 g/mol) how many moles do you have?

  What will be the volume of the gas sample

A gas sample has an original volume of 700 ml when collected at 750 mm and 25°C. What will be the volume of the gas sample if the pressure increases to 810 mm and the temperature increases to 30°C?

  Explain a catalyst lowers the activation energy

A catalyst lowers the activation energy of a reaction from 215 kJ to 206 kJ. By what factor would you expect the reaction-rate constant to increase at 25*C? Assume that the frequency factors

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd