Explain using data from the thermodynamic quantites

Reference no: EM13247179

Using data from the thermodynamic quantites at 298.15 K, calculate delta H^degree, delta S^degree, and delta G^degree at 298K for each reaction. Show that delta G^degree = delta H^degree - T(deltaS^degree)

(A) H2(g) + F2(g) ->2HF(g)

(B) C(s,graphite) + 2Cl2(g) -> CCL4(g)

(D) 2CH3OH(g) + H2(g) -> C2H6(g) + 2H2O(g)

Reference no: EM13247179

Questions Cloud

How can make a low-pass filter with proper cut-off freq : How can you make a low-pass filter with proper cut-off frequency to remove noise from a voice transmission using frequency spectrum What frequency cutoff would you use in that

Explain the final temperature of the combined liquids : If the final temperature of the combined liquids is 28.5°C and the heat capacity of the calorimeter is 19.3 J/°C, determine the specific heat of methanol.

Find the induced surface-charge density on the surface : A capacitor has parallel plates of area 12 cm2 separated by 4.5mm . The space between the plates is filled with polystyrene, Find the induced surface-charge density on the surface of the dielectric

Design an active low pass filter with a cutoff : Design an active low pass filter with a cutoff of 10kHz or more by more than 30db and have the pass band gain positive that does not deviate from 20db by more than 3 db. The pass band frequncy need is 800Hz and below.

Explain using data from the thermodynamic quantites : Using data from the thermodynamic quantites at 298.15 K, calculate delta H^degree, delta S^degree, and delta G^degree at 298K for each reaction. Show that delta G^degree = delta H^degree - T(deltaS^degree)

Variance of the standard normal distribution : The sample proportion and the sample standard deviation are all unbiased estimators of the corresponding population parameters - variance of the standard normal distribution

Estimate the primary current with secondary open : The laminated silicon steel core of a transformer has a mean length of 0.06 m and a cross section of 0.005 meter square. there are 150 turns on primary winding and 450 turns on the secondary. the input is 200 V rms at 50 Hz.

Find the resistivity of the rod : A 1.60m cylindrical rod of diameter 0.450cm is connected to a power supply that maintains a constant potential difference of 15.0V across its ends, Find the resistivity and for the material of the rod at 20 ?C

Explain is the reaction exothermic or endothermic : Is the reaction exothermic or endothermic. Does the reaction lead to an increase or decrease in the disorder of the system

User Account

All Pages