Explain trans-2,2,5,5-tetramethyl-3-hexene is more stable

Reference no: EM13229641

trans-2-Butene is more stable than cis-2-butene by only 4 kJ/mol, but trans-2,2,5,5-tetramethyl-3-hexene is more stable than its cis isomer by 39 kJ/mol. Explain.

Reference no: EM13229641

Questions Cloud

Explain the molar heat capacity of silver : The molar heat capacity of silver is 25.35 J/Mol * degrees celcius. How much energy would it take to raise the temperature of 11.7g of silver by 16.9 degrees celcius?

Explain the h atom and be3+ ion : Which set of the following choices contains all the true statments and none of the false statements? a) The H atom and Be3+ ion each have one electron. Their line spectra are identical.

Evaluate required received power that achieves a bit error : Data at a rate of 2 Mbps is to be transmitted via a pass-band communication system whose carrier frequency is 500MHz. A binary antipodal system with roll-off factor of 0.2 is used for this communication. The AWGN single-sided power spectral densit..

What is the dynamic range for an 8-bit adc : 2) A device that responds to a small current or voltage change by activating a mechanical switch allowing a larger amount of current flow is 3) Where does a program transfer to when an interrupt occurs Interrupt vector table Interrupt service ro..

Explain trans-2,2,5,5-tetramethyl-3-hexene is more stable : trans-2-Butene is more stable than cis-2-butene by only 4 kJ/mol, but trans-2,2,5,5-tetramethyl-3-hexene is more stable than its cis isomer by 39 kJ/mol. Explain.

Compute ?e of the gas in j : A gas is expanded in a cylinder from 2.00 L to 12.0 L against an external pressure of 1.80 atm. At the same time, it absorbs 2.56 x 103 J of heat from the surroundings. Calculate ?E of the gas in J. (1 L•atm = 101.3J)

What should the surface concentration of the boron implant : A Si sample is uniformly doped with phosphorus at 5 E 16 cm^-3. We make a p-n junction by implanting boron atoms into the surface layer. The implanted depth is 0.15 µm. What should the surface concentration of the boron implant

Explain starting with pure nacl and water : Starting with pure NaCl and water, describe how you would prepare 25.00 mL of a NaCl solution? Assume you know how much NaCl you need to weigh on the balance.

Determine the uncorrected poer factor and reactive load : A 2.4KV, single-phase circuit suppllies a load of 250KW at a lagging power factor, and the load current is 160A. If it is necessary to improve the power factor, determine the following: (a)The uncorrected poer factor and reactive load.

User Account

All Pages