Explain the two possible frequencies

Assignment Help Electrical Engineering
Reference no: EM13138446

A radio receiver is tuned to an FM station at 93.7 MHz. (That means the carrier frequency is 93.7 MHz and sidebands extend each side of the carrier). The bandwidth of the FM signal is 180 kHz. The receiver has an IF amplifier with a center frequency of 10.7 MHz.

The signal from the radio's antenna is first amplified in an RF amplifier and then multiplied by a local oscillator signal. A narrow bandpass filter follows the multiplier (mixer).

a. What are the two possible frequencies to which the local oscillator could be set?

b. What bandwidth should the 10.7 MHz IF amplifier have?

c. What is the image frequency for the 93.7 MHz FM signal with a low side LO?

Reference no: EM13138446

Questions Cloud

What is the contribution margin per unit : Padua Corp has sales of $400,000, a variable cost ratio of 60%, and a profit of $40,000. If 10,000 units were sold, what is the contribution margin per unit?
Is there a significant difference in the proportions : In a sample of 80 mail carriers 16 had been bitten. At the 0.05 level of confidence, is there a significant difference in the proportions?
What are the n and l quantum numbers of the electron : The first ionization energy of bismuth is Ei1 = +703 kJ / mol. What is the longest possible wavelength of light that could ionize an atom of bismuth?
Current political events in syria : Draft a paper that critically analyzes a current, domestic or foreign political issue of importance to the United States.
Explain the two possible frequencies : What are the two possible frequencies to which the local oscillator could be set? What bandwidth should the 10.7 MHz IF amplifier have?
Posting process to get the trial balance : What exactly comes after doing the general journal, the special journals. What steps come next after writing these entries. In full detail what steps or what occurs in the posting process to get the trial balance?
What is the minimum acceptable selling price per unit : A special order to purchase 10,000 units was recently received. Kandeed has enough capacity to fill the order, and filling the order would not disrupt current production or sales of K.
How many city residents be surveyed for confidence interval : How many city residents must be surveyed in order to have a 95 percent with a precision of plus/minus 3 trips per month.
Automatic incumbency and political process : Should elected political figures be required to be re-vetted by a bi-partisan committee prior to qualifying for automatic incumbency? What are the potential draw-backs to this?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Evaluate cross or auto correlation

You have to figure out which one using cross or auto correlation.

  Explain the principles of electromagnetic radiation

Explain the structure and nature of the ionosphere with reference to daily, seasonal and long-term changes and explain the modes of propagation of radio waves of different frequencies

  Explain using diagram

If L=0.0053nH, C=15µF find the operating frequency of series LC circuit. What factors decides capacitance? Explain using diagram.

  Explain how an electric shock may occur

A process worker received an electric shock when she attempted to turn off a conveyer control. The toggle switch controlled the power to a variable speed drive. An examination found that dust had accumulated on the toggle switch. Moisture on the ..

  Explain plotting continuous time signal

Plotting Continuous time signal, Consider the following continuous signal: x(t) = 10e^-3t u(t) Using Matlab, plot the continuous-time signal over the range -1=

  Basic neutralizer control system

Write a short report that analyses the P&ID - Basic Neutralizer Control System: The neutralizer process may be used to adjust the pH of a feed stream.

  Depiction impedance diagrams

Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.

  Find out the voltage required on the input

Determine the voltage required on the input of the amplifier to give the maximum output of 85 dBuV. If the signal level from the aerial is 5 dBmV and the input noise level is 20 dBuV, calculate the signal-to-noise ratio on the output of the amplifi..

  Compute the age second harmonic distortion

Calculate the %age second harmonic distortion present in the amplifier's output for a sinusoidal input of 10 mV r.m.s.

  Model a discrete-time system

To understand di erent signal models To be able to model a discrete-time system and design simple signal processing algorithms.

  Solar energy for farms in middle east

Determine the energy uses on farms in middle east and determine whether or not it is better to use a stand alone system or a grid connected system for the application on farms.

  Performance analysis of 16 bit by16 bit mac design

Performance Analysis of 16 Bit by16 Bit MAC design using 5:3 Compressors - 3:2 counters and 4:2 compressors have been widely used for multiplier implementations.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd