Explain the reaction flask instead of 1-hexene

Assignment Help Chemistry
Reference no: EM13313559

Explain the effect of the following experimental errors on your results: a) You add hexane to the reaction flask instead of 1-hexene b) You use 3% hydrogen peroxide instead of 30% c) You forget to add potassium carbonate in the seperation step.

Reference no: EM13313559

Questions Cloud

Explain why the atomic packing factor of fcc steel is less : Iron can exist in the FCC or BCC structure. For FCC iron, the crystal lattice parameter is a=0.3515nm and the atomic packing factor is 0.74. In an FCC structure, iron atoms have an atomic radius of 0.1263nm.
Explain the approximate value of ka for nicotinic acid : The pH of a 0.10 M nicotinic acid solution is 2.93. What is the approximate value of Ka for nicotinic acid, HC6H4NO2? Assume small percent dissociation. pH = ?log10[H+].
Calculate data bandwidth requirements from and to each site : The next three questions relate to voice communications. Note that this topic was not covered in the class, but it is included to encourage self-learning. research, and analysis.
Find the maximum principal effective stress at failure : Given the initial effective stress state at a point within a soil mass (s_y=2.5 daN/cm2, s_x=1.5 daN/cm2, t_xy=t_xy=0.4 daN/cm2) and effective soil shear strength parameters at the same point
Explain the reaction flask instead of 1-hexene : Explain the effect of the following experimental errors on your results: a) You add hexane to the reaction flask instead of 1-hexene b) You use 3% hydrogen peroxide instead of 30% c) You forget to add potassium carbonate in the seperation step.
Calculate volume of sample that will be used in bod bottle : If a sample for BOD needs to be diluted by a factor of 0.02 , calculate the volume of sample that will be used in the BOD bottle
What are the eigenvalues of g : #2: Let G be the graph with vertex set Z_2^n( the same as the n-cube) and with edge set defined as follows: {u, v} is an edge of G if u and v differ in exactly two coordinates (i.e., if ω( u, v) = 2). What are the eigenvalues of G?
Determine what would be the relative compaction in the field : The maximum and minimum dry unit weights of a sand were determined in the laboratory to be 104 lb/ft^3 and 93 lb/ft^3, respectively. what would be the relative compaction in the field if the relative density is 78%
Determine the effective spring constant : a typical sedan ( like corolla Toyota) has unloaded mass of 1.2x10^3 kg. Determine the effective spring constant "k" for the suspension system for critical damping

Reviews

Write a Review

Chemistry Questions & Answers

  Explain when ethane (c2h6) reacts with chlorine

You may want to write out the reaction)When ethane (C2H6) reacts with chlorine (Cl2) the product is C2H5Cl and HCl. In a certain experiment 165 g of C2H6 reacts with 255 g of Cl2.

  Explain an unknown solution containing one of the salts

An unknown solution containing one of the salts ZnSO4, MgSO4 or SrCl2 gives a negative flame test but tarnishes a piece of magnesium inserted into the solution. Which salt was in the solution

  How many moles of hdrogen can be produced

How many moles of H2 can be produced from x grams of Mg in magnesium-aluminum alloy? The molar mass of Mg is 24.31 g/mol

  Compute the heat of formation

Calculate the heat of formation, Hof, of pentane given that the Hof of H_2O(l) is -285.3 kJ mol-1 and Hof of CO_2(g) is -393.5 kJ mol-1

  Explain water-soluble oils of low volatility

Explain why water-soluble oils of low volatility are not typically isolated by steam distillation.

  Calculate the concentrations of n2o4 and no2

At a particular temperature, K = 4.0 x 10^-7 for the reaction N2O4(g) ---> 2NO2(g). In an experiment, 1.0 mol N2O4 is placed in a 10.0L vessel. Calculate the concentrations of N2O4 and NO2 when this reaction reaches equilibrium.

  What is the magnitude of k

A particular first-order reaction has a rate constant of 1.35 × 10^2 s-1 at 25°C. What is the magnitude of k at 75°C if Ea = 85.6 kJ/mol?

  Haber-bosch process is a very vital industrial process

The Haber-Bosch process is a very important industrial process. In the Haber-Bosch process, hydrogen gas reacts with nitrogen gas to produce ammonia according to the equation 3H2+N2=2NH3

  State the cereal sample without adding complexing agent

The cereal sample without adding complexing agent was used as blank when measuring cereal sample. Why cannot we use DI water?

  Define what product would you expect to obtain from addition

what product would you expect to obtain from addition of Cl2 to 1,2-dimethylcyclohexene? Show the stereochemistry of the product.

  Calculate the minimum volume of water needed to decompose

Calculate the minimum volume of water that is needed to decompose all the excess ethanoic anhydride. Recall: 1.0 g of H2O = 1.0 mL of water, for this purpose

  Compute the rquire flow rate of air in mol

diluted with pure air to reduce the methane concentration to the lower flammability limit . calculate the rquire flow rate of air in mol/h and the precent by mass of oxygen in the products gas

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd