Explain the ph of the solution of naoh have been added

Reference no: EM13260931

A 50 ml sample of .5 M HCl is titrated with .5 M NaOH. What is the pH of the solution after 28 ml of NaOH have been added to the acid?

Reference no: EM13260931

Questions Cloud

Find charge and voltage on capacitor after a very long time : An initially uncharged 2 microfarad capacitor is connected in series with a 10 k-ohm resistor and a 12 V battery. Find the charge and voltage on the capacitor after a very long time and find the voltage and charge on the capacitor after one time co..

Are there any particular financial ratios : classification when assessing the investment merits of a given company? Please list and discuss up to three ratios you believe meet this criteria, and explain [with real life examples] your reasoning.

Calculate the potential difference across each capacitor : Three capacitors are connected in series across a 100 V battery. If the capacitances are 1 microfarad, 0.1 microfarad, and 0.01 microfarad, respectively, calculate the potential difference across each capacitor.

Determine the initial charge on the capacitor : If a 2 microfarad capacitor is charged to 12 volts and then connected across a resistor of 100 ohms: Determine the initial charge on the capacitor, initial current through the 100 ohm resistor and the time constant.

Explain the ph of the solution of naoh have been added : A 50 ml sample of .5 M HCl is titrated with .5 M NaOH. What is the pH of the solution after 28 ml of NaOH have been added to the acid

How to design the widlar circuit using the diode equation : A Widlar Current Source is designed to limit the load current to the reference current by using a resistor at the emitter end by:I(load)*R(Emitter)=Vt ln (I(ref)/I(load))=VBE(Ref)-VBE(Load)

What are the firm market value capital structure weights : The market risk premium is 8.2 percent, T-bills are yielding 3 percent, and Titan Mining's tax rate is 35 percent.

Calculate the average bit error rate within the test period : A 4800 bps data transmission device has a bit error rate of 10-6 normally. During a test period, it works at normal conditions except that a 1000ms impulse saturates the channel and all data is lost. Calculate the average bit error rate within the..

What relation should 2-parameters satisfy to maintain output : A repeater has an input signal of 150μW and an output signal-noise ratio of 20 dB. The repeater has a gain of A and additional noise of N. What relation should the two parameters satisfy to maintain an output noise figure less than 2 dB

User Account

All Pages