Explain the boiling points of pure benzene

Assignment Help Chemistry
Reference no: EM13295609

Construct an approximate boiling point composition diagram for a Benzene-Methanol system. The mixture shows azeotropic behavior. Include on the graph the boiling points of pure benzene and pure methanol and the boiling point of the azeotrope. Describe the behavior for a mixture that is initially rich in Benene (90%) and then for a mixture that is initially rich in methanol (90%).

Reference no: EM13295609

Questions Cloud

Explain what mass of carbon dioxide was produced : When carbon is burned in air, it reacts with oxygen to form carbon dioxide. When 14.4 g of carbon were burned in the presence of 50.6 g of oxygen, 12.2 g of oxygen remained unreacted. What mass of carbon dioxide was produced
How to calculate the thermal efficiency of power station : the daily output of a steam power station is 18x105 kwh. If the coal consumption is 700 tons per day calculate the thermal efficiency of power station .assume calorific value of coal 8500 kcal/kg
Estimate the phase angle between the current and the voltage : A 80.0 Hz generator with an rms voltage of 150 V is connected in series to a 3.20 k ohm resistor, estimate the phase angle between the current and the voltage
What is the value today of the following payments : What is the value today of the following payments: Year 2 $600, Year 4 $1,300, Year 5 $900, and Year 6 $1,800, if the appropriate interest rate is 5%? What is the value of these payments as of the end of year 4?
Explain the boiling points of pure benzene : Include on the graph the boiling points of pure benzene and pure methanol and the boiling point of the azeotrope. Describe the behavior for a mixture that is initially rich in Benene (90%) and then for a mixture that is initially rich in methanol ..
How much are the monthly loan payments : She will have to borrow $3,650 in order to make the trade. The bank provides a loan that must be paid off in 18 months. The loan charges interest at the rate of .5% per month. How much are the monthly loan payments?
Calculate the impulse of ideal filter with cut-off frequency : calculate the impulse of an ideal filter with cut-off frequency of a)2KHz, and b)3KHz for a signal sampled with a rate 8000 samples/sec.
Calculate the max static friction force that acts on block : a block with a mass of 2.50kg is resting on a ramp. find the max static friction force that acts on the block.
What interest rate is that investor receiving : If an investor were to purchase an annuity for $3,200 to receive $260 at the end of each year for 16 years, what interest rate is that investor receiving?

Reviews

Write a Review

Chemistry Questions & Answers

  Explain what is the mass of the steel bar

A volume of 125 mL of H2O is initially at room temperature (22.0*C). A chilled steel rod at 2.00 *C is placed in the water. If the final temperature of the system is 21.1*C, what is the mass of the steel bar?

  Explain sulfuric acid acts as a catalyst for making esters

sulfuric acid acts as a catalyst for making esters. Write an equation showing the production of Isoamyl alcohol

  Calculate the energy, frequency and wavelength

The Lyman series in the hydrogen atom corresponds to transitions that originate from the n=1 level in absorption or that terminate in the n=1 level for emission. Calculate the energy, frequency, and wavelength of the least and most energetic transiti..

  Explain excess of concentrated sulfuric acid

Ethanol (molar mass = 46 g/mol) can be dehydrated to yield ethene (molar mass = 28 g/mol) by heating it with an excess of concentrated sulfuric acid (acting as a catalyst).

  Determine the molarity of ethanol

An aqueous solution is six percent by mass methanol,, and has a density = 0.988 g/mL. Determine the molarity of ethanol in the solution.

  Compute the delta g

Calculate the delta G at 400K for the following phase change: Sulfur(monoclinic) to sulfur rhombic. Do not assume that delta H or delta S are independent of temperature

  Explain what temperature would you expect the solution

If you were to dissolve 15.0 mg of the antibiotic in 546 mg cyclohexane, at what temperature would you expect this solution to boil

  Describe why this series of reaction will produce

explain why this series of reaction will produce the 3,5-dibromotoluene and direct bromination of toluene produces the 2,4-dibromotoluene.

  Determine the order of reaction

at 400 K, the rate of decomposition of a gaseous compound initially at a pressure of 12.6 kPa, was 9.71 Pa/s when 10.0 % had reacted and 7.67 Pa when 20.0 % had reacted.Determine the order of reaction.

  How many joules of energy are needed to melt ice

How many joules of energy are needed to melt 54 grams of ice at its melting point? Assume that the molar heat of fusion of ice is 6 kJ/mol.

  State the final temperature of the water

Suppose that 5193.0 J of heat energy is added to 7 g of ice initially at -10 C. (This could be done, for example, by electrical heating of ice in an insulated container.) What is the final temperature of the water

  Explain neon crystalizes in a face-centered cubic lattice

Neon crystalizes in a face-centered cubic lattice. It's density is 1.45 g/cm3. What is the edge length of the unit cell? Note: The atomic weight of Ne is 20.2 g/mol, and Na is 6.02 x 10^23/mol

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd