Explain the approximate value of ka for nicotinic acid

Assignment Help Chemistry

Reference no: EM13313562

The pH of a 0.10 M nicotinic acid solution is 2.93. What is the approximate value of Ka for nicotinic acid, HC6H4NO2? Assume small percent dissociation. pH = ?log10[H+].

Reference no: EM13313562

Questions Cloud

Evaluate damage of material and compressive strength : A structural element subjected to cyclic loading is made of fc' = 3000 psi concrete. Compressive stresses are changing between 2200 psi and 1600 psi. The frequency of loading is 8 Hz.

Compute the maximum wavelength of light : It takes 151 kj/mol to break an iodine-iodine single bond. Calculate the maximum wavelength of light for which an iodine-iodine single bond could be broken by absorbing a single photon.

Benny the barber owns a one-chair shop : Benny the Barber owns a one-chair shop.

Explain why the atomic packing factor of fcc steel is less : Iron can exist in the FCC or BCC structure. For FCC iron, the crystal lattice parameter is a=0.3515nm and the atomic packing factor is 0.74. In an FCC structure, iron atoms have an atomic radius of 0.1263nm.

Explain the approximate value of ka for nicotinic acid : The pH of a 0.10 M nicotinic acid solution is 2.93. What is the approximate value of Ka for nicotinic acid, HC6H4NO2? Assume small percent dissociation. pH = ?log10[H+].

Calculate data bandwidth requirements from and to each site : The next three questions relate to voice communications. Note that this topic was not covered in the class, but it is included to encourage self-learning. research, and analysis.

Find the maximum principal effective stress at failure : Given the initial effective stress state at a point within a soil mass (s_y=2.5 daN/cm2, s_x=1.5 daN/cm2, t_xy=t_xy=0.4 daN/cm2) and effective soil shear strength parameters at the same point

Explain the reaction flask instead of 1-hexene : Explain the effect of the following experimental errors on your results: a) You add hexane to the reaction flask instead of 1-hexene b) You use 3% hydrogen peroxide instead of 30% c) You forget to add potassium carbonate in the seperation step.

Calculate volume of sample that will be used in bod bottle : If a sample for BOD needs to be diluted by a factor of 0.02 , calculate the volume of sample that will be used in the BOD bottle

User Account

All Pages