Explain linear equations and outputs

Assignment Help Mechanical Engineering
Reference no: EM13137318

Linear equations and outputs

An AC sine wave is applied to the input of a full wave rectifier. The output of the full wave rectifier is then applied to a half wave rectifier. The output of the half wave rectifier will most closely resemble:

A) the original sine wave.
B) an inverted form of the original sine wave.
C) the output of the full wave rectifier.
D) none of the above.

A project that will cost $750,000 will require payments as certain milestones are met. The initial payment is $50,000. When 30% of the work is complete an additional payment of $200,000 is due. When 70% of the work is complete another payment of $300,000 is due. Upon completion of the project the balance is due. The closest linear equation to approximate the payment schedule (where Y = amount paid in thousands of dollars, and X = % complete) is:

A) 750 X - Y = 0
B) 750 X - Y = - 50
C) 600 X -Y = -100
D) B = 0

Approximately where would the curve, log Y = log 2X plotted on standard graph paper intercept the Y-axis?

A) 0
B) 0.3
C) 1.0
D) 2.3

An electrical circuit consists of a set of three parallel resistors (A, B, and C) which are connected in series with another set of two parallel resistors, (D, and E). These two sets of resistors are connected in a series loop to a battery. Assume the following resistor values:

A = 33 ohms
B= 100 ohms
C = 51 ohms
D = 22 ohms
E = 10 ohms

How much current could a 12 V battery drive through the circuit?

A) less than 12 ohms
B) greater than 1 amp
C) less than 0.5 amps
D) none of the above

An object is thrown horizontally from the top of a building from an elevation of 64 feet above ground level. The velocity of the object is 56 miles per hour. How far, horizontally will the ball travel before reaching the ground?

A) Less than 170 feet.
B) Less than 160 feet.
C) Each of the above.
D) None of the above.

A football player runs at a speed of 16 feet per second. How long will it take him to run ten yards directly downfield if his course is in a forward direction at an angle of 45 degrees toward the sideline?

A) Less than 2 seconds.
B) More than three seconds.
C) Cannot be determined from the information provided.
D) None of the above.

Reference no: EM13137318

Questions Cloud

Application envelopes at random looking for ten applicants : The application envelopes at random looking for 10 applicants with GRE scores over 600. How many envelopes do you think the staff will need to open?
Wmd and us policies on terrorism : How have worries over WMD terror attacks distorted a balanced approach to policy on terrorism? How do the current trends in terrorism affect the United States?
Decision making and cuban missile crisis : Discuss Khrushchev's decision to put missiles into Cuba. What was he trying to achieve and what were the flaws in his analysis? Use Allison's level of analysis approach to explain.
Journal entry to record accrued interest : The journal entry to record accrued interest on a short-term note payable must include an increase to:
Explain linear equations and outputs : A project that will cost $750,000 will require payments as certain milestones are met. The initial payment is $50,000. When 30% of the work is complete an additional payment of $200,000 is due. When 70% of the work is complete another payment of $..
Which statements is accurate with respect to the federal : Under Carl's will, Carl created a testamentary trust to be funded with $700,000 worth of assets. All of the income of the trust is payable to Carl's child, Jane, for her life, and thereafter, the remaining assets of the trust will pass to The Publ..
Computer security and etiquette are critical incommunication : Computer security and etiquette are critical in effective communication. Each day we must be careful to insure that our personal information is not compromised. Computer etiquette is critical for effective communication.How does proper computer etiqu..
Carry out hypothesis test to see if claim may be refuted : Carry out a hypothesis test to see if this claim may be refuted. State the null hypothesis and the alternative hypothesis that we would use for this test.
Calculate discount rate used by the lender : Columbo Co treasurer signed a note promising to pay 240000 on December 31 2010 .The proceeds of the note were 232,000 . calculate discount rate used by the lender

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Package design

Package Design Brief: Assume you are the packaging engineer for a large consumer products company. In this company, the Packaging Design Briefs are initiated by the marketing group and forwarded to the Package Engineering group.

  Mechanical engineering questions

Define dynamic viscosity, Determine the centroid, Pressure due to the height of liquid, Advantage of changing the liquid, Calculate the total moment about the hinge of the seal gate.

  Automatic control

DOF system and Find the differential equation describing the system

  Write a paper on boyle''s law

Write a paper on Boyle's law and describe Compression and Combustion stroke . Also explain Charles's law and illustrate SI engine and CI engine.

  Verify the law for parallelogram of forces

To Verify the law for parallelogram of forces, law for triangle of forces and law of polygon of forces. These laws are very useful to calculate unknown forces in very short time.

  Discharge pressure of the compressor

What is the discharge revised discharge pressure of the compressor.

  The Case for Global Accounting Standards

The role of IFRS in both developing and developed capital markets.

  Wind turbine

Wind turbines are becoming more and more common as a method of energy production, wind turbines by their very nature are dynamic and are subject to and create their own internal and external kinematics and kinetics.

  Advanced design methodologies

8 x product engineering and design review (week 2 – 12), ~3 pages per item which must contain a brief description of the product then delve into concepts such as materials selection, manufacturing methods, life cycle analysis, recyclability and overa..

  Design of absorption column and the cooler

Design of absorption column and the cooler. Process design of other units should be completed along with pipe sizes.

  Determine the maximum total bending moment

Determine maximum total bending moment (static plus dynamic) of the beam under steady-state conditions.

  Force of the water on the gate

Determine the magnitude of the horizontal and vertical components of the force of the water on the gate.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd