Explain how to recover the increased design cost

Assignment Help Electrical Engineering

Reference no: EM13229555

a cost to produce, P, of $4.00. If we were able to reduce this to $3.55 through greater attention in the design, and if the cost to improve the design (in NRE) is $35,000, how many units must we sell to recover the increased design cost? Calculate for both the = 50% and = 75% cases.

Reference no: EM13229555

Questions Cloud

Explain heating a with hydrazine in base gave hydrocarbon c : When optically active B was treated with CrO3 in pyridine, an optically inactive sample of A was obtained. Heating A with hydrazine in base gave hydrocarbon C, which, when heated with alkaline KMnO4, gave carboxylic acid D. Identify compounds A, B..

Explain causes of difference between the emitted radiation : Compare this spectral distribution with that of the radiation received on the surface of the earth at AM1.5. Briefly explain the causes of the difference between the emitted radiation of the core of the sun and the received radiation at the earth'..

Explain the proton nmr spectrum of compound d : Ozonolysis of C followed by treatment with Zn and water gives CH3CHO and compound D (C9H10O). The proton NMR spectrum of compound D is given below. Treatment of compound D with ethyl magnesium bromide yields A. Draw the structures of compounds A, ..

What are earnings as a percentage of the final retail price : In the electronics business, mark-up is in the order of 100% to 130% at each level of middleman. Let's say that it is 100%. Let's further say that your product passes through three levels of middleman, that your product is produced in accordance

Explain how to recover the increased design cost : a cost to produce, P, of $4.00. If we were able to reduce this to $3.55 through greater attention in the design, and if the cost to improve the design (in NRE) is $35,000, how many units must we sell to recover the increased design cost

Examine the role of advertising and promotion management : Examine the role of advertising and promotion management in contemporary marketing and develop an understanding of integrated marketing communications, including the coordination of the various promotional mix elements

Find the reflection coefficient at the load : A 75- ohm lossless transmission line is interfaced to a load impedance that consists of a series connected resistor of 30 ohm and a capacitor of 10 pF. At an operating frequency of 2 GHz and for a wavelength of 10 cm.

Determine the total power in fm signal : An FM signal being transmitted is represented by eFM(t) = 50Sin((2)(95.1)(106)t+2Sin((2)(10)(103)t)). If the antenna impedance is 75 , determine: (a) total power in FM signal and (b) FM modulation index.

What is the adt output for a temperature of 81 degrees : A HCS12 ATD is set to 10-bit unsigned mode. The voltage references are set to ground and 1.0V What is the ADT output for a temperature of 81 degrees The temperature sensor measures 0 to 100 degrees with an output of 10 mV/degree.

User Account

All Pages