Explain how to design a logic network to control the lights

Assignment Help Electrical Engineering
Reference no: EM13288046

A long hallway has three doors, one at each end and one in themiddle. A switch is located at each door to operate the lightsalong the hallway. Label the switches X, Y, and Z. Design a logicnetwork to control the lights.

Reference no: EM13288046

Questions Cloud

Which resistor in the circuit absorbs the most power : the bridge circuit is energized from a 21 V dc source. the bridge is balanced when R1 = 800Ω, R2 =1200Ω, and R3 = 600Ω. a) what is the value of Rx b) how much current(in milliamperes) does the dc source supply
Determine the tension in the middle : A nanowire is a (nearly) one-dimensional structure with a diameter on the order of a few nanometers. What is the tension in the middle
Calculate the average acceleration vector of the football : As a function of time, the velocity of the football can be written as. Calculate the average acceleration vector of the football
What would be the acceleration of the trunk : A trunk with a weight of 230 N rests on the floor. The coefficient of static friction between the trunk and the floor is 0.32, what would be the acceleration of the trunk
Explain how to design a logic network to control the lights : A long hallway has three doors, one at each end and one in themiddle. A switch is located at each door to operate the lights along the hallway. Label the switches X, Y, and Z. Design a logicnetwork to control the lights.
Define the functional group in the molecule : A sample of a liquid from an unlabeled bottle was subjected for analysis: MS showed that M+ has an m/z of 89 and IR displayed bands at 2995-2840 cm-1, and 1562, and 1425. Identify the functional group in the molecule and provide 2 possible structu..
What is the friction force of the water : one of your classmate has a friend with a boat. here is your classmate on water-skis being towed. what is the friction force of the water
Determine the sepaaration between the two runners : One runner ran the 100-m dash in 11.9 s. Another runner came in secona at 12.4 s. determine the sepaaration between the two runners
Which of the following is not true if interest rates rise : Which of the following is not true if interest rates rise?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Design a simple power factor meter to operate from mains

1. design a simple power factor meter to operate from 230v mains. current range=1 to 10 amps. power factor range : 0.4 to 1 2. what is meant by normal mode rejection an A/D converter has 20ms integration time.

  What is this pressure in units of atmospheres

1- A particular gas exerts a pressure of 2.79 bar. What is this pressure in units of pascals 2- A particular gas exerts a pressure of 3.43 bar. What is this pressure in units of atmospheres 3- A particular gas exerts a pressure of 4.79 atm.

  Find charge and voltage on capacitor after a very long time

An initially uncharged 2 microfarad capacitor is connected in series with a 10 k-ohm resistor and a 12 V battery. Find the charge and voltage on the capacitor after a very long time and find the voltage and charge on the capacitor after one time co..

  What voltage is induced in 1000 turn coil by change in flux

a change in the coil over a period of 4mSec causes total flux in the core to decrease at a constant rate by a total of 0.10 mWb. What voltage is induced in the 1000 turn coil by the change in flux.

  Find the overall voltage gain when the follower is driven

An emitter follower, when driven from a 10 kohm source, was found to have an output resistance Rout of 200 ohm. The output resistance increased to 300 ohm when the source resistance was increased to 20 kohm.

  What is the minimum resistance such that the current is less

Suppose your multimeter is fused for 300 mA. You want to measure current through a resistor via a 9-volt battery. What is the minimum resistance such that the current is less than 150 mA

  Determine the noise floor for the mobile receivers

The channel bandwidth for the analog AMP's system is restricted to BW= 30 kHz. Determine the noise floor (in dBm) for its mobile receivers assuming all receivers have a noise figure of 10 dB.

  Find the natural reponse of current for rlc circuit

Consider a series RLC circuit disconnected from a source at t=0. The circuit components are R=3 ohms, C = 500 F, and L = 1 H. We assume that Vc(0-) = 20 V and i(0-) = -0A.  a) Find the natural reponse i(t) for t > 0.

  Design a full subtractor circuit which computes a-b-c

Design a full subtractor, that is a circuit which computes a-b-c, where c is a borrow from the next less significant bit. (Hint: Denote the difference as d, and a borrow from the next more significant bit as p, then develop a truth table for the p..

  Find how much power is dissipated by the transistor

at room temp a power transistor has beta of 160 and it is used in a DC dimmer circuit to control a 24 volt 120 watt lamp the lamp power supply is 48 volts dc and it can deliver a maximum of 21 amperes of current

  What is the rate of change of the voltage on the capacitor

The switch in a RC circuit is closed. If the resistance is 134462ohms, the capacitance 7.5 microF, and the applied voltage 18 volts, what is the (average) rate of change of the voltage on the capacitor, to the nearest tenth of a V/s, during the fi..

  Find the thermal-equilibrium electron and hole concentration

Calculate the thermal-equilibrium electron and hole concentrations in a compensated p-type semiconductor. Consider a silicon semiconductor at T=300K in which Na = 10e16 cm-3 and Nd=3x1015 cm-3. Assume ni = 1.5 x1010 cm-3.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd