Explain how ductility may be accomplished

Assignment Help Civil Engineering

Reference no: EM13320203

A cylindrical rod of 1040 steel originally 15.2 mm (0.60 in.) in diameter is to be cold worked by drawing; the circular cross section will be maintained during deformation. A cold-worked tensile strength in excess of 840 MPa (122,000 psi) and a ductility of at least 12%EL are desired. Furthermore, the final diameter must be 10 mm (0.40 in.). Explain how this may be accomplished.

Reference no: EM13320203

Questions Cloud

Determine the ratio of their activities at this instant : Two different elements with half lives Ta and Tb have Na & Nb (undecayed) atoms respectively, Determine the ratio of their activities at this instant

Iterative and incremental developments : Iterative and Incremental developments: focusing on unified Software

Calculate energy loss and approximate dimension of the jump : A wide rectangular channel has a change of slope from 1 in 100 to 1 in 500 and the flow is 4m3/s/m. Manning's n can be taken as 0.015 Determine the normal depth of flow before and after the change in gradient.

Find the total impedance in this circuit : A coil with inductance 370 mH is connected in series with a 220 ohm resistor, a 47.0 microF capacitor and a 25.0 V, 60.0 Hz AC source. Find the total impedance in this circuit

Explain how ductility may be accomplished : A cylindrical rod of 1040 steel originally 15.2 mm (0.60 in.) in diameter is to be cold worked by drawing; the circular cross section will be maintained during deformation.

An estimated residual value : Equipment replacement decision Columbia Enterprises is studying the replacement of some equipment that originally cost $74,000. The equipment is expected to provide six more years of service if $8,700 of major repairs are performed in two years.

What would be melissas after-tax income : What would be Melissa's after-tax income from the part-time job, considering Social Security and Medicare tax (use 7.65%) as well as Federal income tax on the earnings of $5,000? (Round your intermediate computations and final answer to the neares..

What minimum power must be supplied to the coils : A concrete slab is 9.7 cm thick and has an area of 4.6 m^2. What minimum power must be supplied to the coils to maintain a temperature difference of 17.3 Degrees C between the bottom of the slab and its surface

Determine the depth of flow immediately upstream of the hump : A rectangular channel of 2 m depth and 5 m width carries 1 m deep running water. It is laid to a slope of 0.001 with Manning's n = 0.02. Some distance downstream there is a hump of height 0.5 m on the stream bed.

User Account

All Pages