Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A SPLD that has a programmable AND array and a fixed OR array is PAL; PROM; PLA; GAL 8. A SPLD that has a re-programmable AND array is PAL; PROM; PLA; GAL
1. A GAL is different from a PAL because A GAL has more inputs and outputs; A GAL is implemented with a different technology; A GAL can replace several different PAL's; A GAL can be reprogrammed and a PAL cannot;
2. To program a given PLD device, you need only a special fixture; a special fixture and a master PLD that has been preprogrammed at the factory; a computer and a programmer; a computer, a programmer, and HDL software; a computer, a programmer, and BASIC software;
3. Explain the difference between the registered mode and the combinational mode for PLDs
Explain the difference between hard-decision and soft-decision decoding in partial response signaling, including the relative advantages and disadvantages of each.
In 2012, Felix Baumgartner jumped from space 36.6 km above New Mexico he reached a speed of 834 mph in 4 minutes and 19 seconds. What was his speed in Kilometers per second and how many miles was he above the ground
The parking lot of the Spenditall Megamall has an area of 128 ac. It is partially landscaped to provide some areas of grass. Assume that an average of 63% of the water that falls on the parking lot will flow
Write a script that determines whether an amino acid is going to bind to a certain molecule. It is know that the first region (1-5) of the molecule binds strongly to amino acids A, C, I, L, Y and E, and weakly to W, S, M, G, and K.
We represent this by a non-overlapping sequence detector. In other words, asa soon as you detect the sequence, you will need to get another complete sequence to unlock. Therefore, you need to carefully choose to which state you will need to go.
Can you confirm-The outputs of two"NAND" gates are connected to the inputs of an "EXCLUSIVE OR" gate.Each of the "NAND" gates has one input at logic high level and the other input
Briefly discuss the source of solar energy and the processes involved by which the earth receive 5.7kWh/m^2/day over the entire surface. If it becomes possible to simulate the same process on earth
Assume that a receiver has a first amplifier stage with a 5K input resistance, a power gain of 300, an input audio signal of 20 uV, and an operating temperature of 27'C. When the amplifier is operating with a bandwidth first of 10 MHz
The toggle switch has been closed for two minutes. During the first 15 seconds after the closing of the toggle switch, pushbutton I2 was pressed four times. Describe what the status of the motor and the pilot light (PL) will be at the two minute m..
Design a current divider that will provide a 1/3-2/3 current splitting ratio. Use resistance in kilo ohm range. Redesign the current divider so that the resistors are less than 100 ohms but maintain the same 1/3-2/3 splitting ratio.
A series-resonant RLC circuit has R = 80 ?, L=25mh, and C=10pF. A) Sketch and label the circuit. B) Find fo, the resonant frequency. C) At what frequency is impedance a minimum D) What is the magnitude of the impedance at this frequency
Traffic lights are being converted from incandescent bulbs to LED arrays to save operating and maintenance costs. Typically each incandescent light uses three 100-W bulbs, one for each color R,Y,G,A competing LED array consists of 61 LEDs.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd