Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
(1) Can the op Amp have a gain less than 1? If so, what would that be used for?
(2) Discuss different applications that could use non-inverting and inverting amplifier circuits. Will the actual op Amp characteristics cause any challenges it used for each application?
Design a DC power supply that provides -95v +/- 5v to a 2 amp load (energy absorber). The input source is a 100 volt peak sinusoid, 60 Hz. You may use any circuit element we've studied. State the values of all circuit elements
Box 1 contains 1000 Integrated Circuits of which 10% are counterfeit. Box 2 contains 2000 Integrated Circuits of which 5% are counterfeit. Externally, all IC's look identical. Two integrated circuits are picked from a (single) randomly selected bo..
a. Given the random binary data sequence 0110001011, provide waveform sketches for (i) NRZ change and (ii)split phase. b.Demonstrate satisfactorily that the split phase waveform can be obtained from the NRZ waveform.
The RS-232 serial port on a personal computer is transmitting 2400-bit/sec data using a polar NRZ line code that has a peak value of 12 V. Assume that binary 1's and 0's are equally likely to occur.
An input signal given by Vin(t)=5cos(500pi*t)+5cos(1000pi*t)+5cos(2000pi*t) is applied to a basic lowpass RC filter. R=318.3 ohms and C=1 microFarad. Find the expression for the output signal in terms of t and pi.
Find the Laplace transform of a rectangular voltage pulse that is 0 V until time 0 s, then jumps to 5 V and stays there until time 2 ms, then returns to 0 V and stays there after time 2 ms. Hint: express the pulse in terms of unit step functions.
A silicon p-n-p transistor has impurity concentrations of 5*10^18, 2*10^17, and 10^16 cm^-3 in the emitter, base, and collector, respectively. The base width is 1.0 um and the device cross-section area is 0.2 mm^2.
A PLL frequency synthesizer has a variable -modulus prescaler of M=10/11 and divider ratios of the A and N COUNTERS OF 40 and 260. the reference frequency is 50khz. what are the VCO OUT PUT FREQUENCY and the minimum frequency step increment
Next find a 95% confidence interval for the proportion theta of defective chips and also find a one sided 95% confidence interval for the proportion of defective ones. Refering to this problem, how large a ssample should be taken
Consider a long wire represented as distributed RC sections. The total wire length is 5mm. To reduce the wire delay, we uniformly insert n buffers along the wire. Suppose r=12Ohms/m and c=0.2fF/m and the delay of each buffer is 1ns.
Two coupled coils have self-inductances L1 = 50 mH and L2 = 200 mH, and a coefficient of coupling k = 0.5. If coil 2 has 1000 turns, and I1 = 5Sin (400t) (i.e. the phasor current is 5? -90° A). Find the voltage at coil 2 and the flux through coil ..
051 Microprocessor a. Write a sequence of instructions to initialize and run the timer to geneate an 800 baud rate clock. b. what would be the baud rate if the intial value of the itimer was set to 9AH
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd