Explain an open tubular chromatography column

Assignment Help Chemistry
Reference no: EM13266055

An open tubular chromatography column is 31.8 m long and has an inner diameter of 0.528 mm. The inside wall is coated with a layer of stationary phase 3.2 ?m thick. Unretained solute passes through the column in 2.23 min, while a certain solute has a retention time of 19.56 min.

(a) What are the linear and volume flow rates?
(b) What is the capacity factor, k\', and the partition coefficient, Cs/Cm, for this solute?
(c) What fraction of time did the solute spend in the stationary phase?

Reference no: EM13266055

Questions Cloud

What will the output voltage be for a strain of 1000 : A resistor on a Wheatstone bridge is replaced with a strain gage which has a nominal resistance of 120 Ohms and a gage factor of 2.06. The remaining resistors on this quarter-bridge Wheatstone bridge circuit are 120 Ohm fixed resistors.
Evaluate the fraction of argon gas molecules : Using the Maxwell-Boltzman function, calculate the fraction of Argon gas molecules with a speed of 305 m/s at 500 K. Please show all of your work and all of your derivations.
What is the major difference between the lm324 and the lf347 : From a high-level perspective, what is the major difference between the LM324 and the LF347. Which of the performance characteristics are significantly different because of this.
Calculate the kinetic energy of sphere : A solid sphere rolls without slipping or sliding along a horizontal surface toward an incline. Calculate the kinetic energy of sphere as it rolls along the horizontal surface
Explain an open tubular chromatography column : An open tubular chromatography column is 31.8 m long and has an inner diameter of 0.528 mm. The inside wall is coated with a layer of stationary phase 3.2 ?m thick. Unretained solute passes through the column in 2.23 min, while a certain solute ha..
Calculate the powers p1 and p2 dissipated across r1 and r2 : A battery E (e.m.f 12v and internal resistance 0.8 ohms) and a resistor R1 (10 ohms) are connected in series across two parallel resistors (R2 = 12 ohms, R3 = 18 ohms). i) Draw the circuit diagram, determine the battery terminal voltage.
Determine the minimum uncertainty in position : What is the minimum uncertainty in position, in nm, of an electron whose velocity is known to be between 2.30×105m/s
Discuss the importance of implementation : Discuss the importance of implementation and monitoring in problem solving.
Creation of managed healthcare : Essay explores and reviews the actions which led to the creation of managed healthcare and its development to its present state in America.

Reviews

Write a Review

Chemistry Questions & Answers

  Describe effects of leachate from landfills

I am trying to understand the effects of leachate from landfills and its effects on groundwater, and since I am in environmental health- its effects on the human health.

  Define methods for converting benzene

Calculate the % atom economy for the following two methods for converting benzene, C6H6, to aniline, C6H5NH2. Method 1: C6H6 + (CH3)3SiN3 + 2 F3CSO3H + NaOH

  Chemical equation for the formation of methionyl glycine

Write a chemical equation for the formation of methionyl glycine from the constituent amino acids.

  Define what is the formula for the limiting reagent

What is the maximum amount of iron(III) oxide that can be formed. What is the FORMULA for the limiting reagent.

  Explain the mass percent of liclo in the sample

The sample requires 48.24 mL of 0.08893 mol/L Na2S2O3 to reach the equivalence point. Assuming that the AU3+ and Li+ ions are unreactive during the titration, determine the mass percent of LiCLO in the sample.

  Explain what maximum mass of aluminum chloride

Solid aluminum reacts with chlorine gas to produce solid aluminum chloride. If 2.70 grams of aluminum and 4.05 grams of chlorine gas were mixed, what maximum mass of aluminum chloride could be produced?

  State how would the enthalpy of the reaction changed

If replacing magnesium with an equal weight of sodium, how would the enthalpy of the reaction changed?

  Computing new ph

Calculating new pH, a). How many mL of each of 0.10M lactic acid solution and 0.10M NaOH solution are needed to make 800mL of a buffer of pH 3.50?

  Explain what is the gauge pressure of the gas

What is the gauge pressure of the gas in this mercury manometer

  Define nonbonding domains

For the following please provide the # of bonding domains, # of nonbonding domains, polarity, intermolecular attractive forces, and which IMAF is the most important.

  Determine the concentration of ammonia in the solution

A solution is prepared by dissolving 0.18 moles of acetic acid and 0.18 moles of ammonium chloride in enough water to make 1.0 L of solution. Find the concentration of ammonia in the solution.

  State drugs designed to reduce cholesterol target the liver

why is significant serum (in the blood stream) chlorestrol reduction so difficult, and why do most of the drugs designed to reduce

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd