Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Analysing an RF splitter and power levels
A splitter is a device that has a single input and several outputs. It is used to send a signal to several different locations. For example, your apartment or house might have cable TV that delivers a wideband signal via a coaxial cable. A splitter can be used to send the same signal to different rooms so that individual TV sets can receive all the programs and channels that are available from the cable TV company. This problem is about a splitter with three outputs.
A broadband signal with analog TV signals from 50 MHz to 600 MHz is connected to the input of the splitter. At a channel frequency of 50 MHz the input power is -20 dBm. The output power at each of the three splitter output terminals is - 27 dBm.
a. What is the power at the splitter input in mW?
b. What is the power at each splitter output in mW?
c. What is the total output power from the splitter (add the three outputs together)?
d. Why is the total output power not equal to the input power?
Assuming that ideal filters are available, what is the lowest frequency at which the signal can be sampled and subsequently recovered in its analog form without distortion using a low pass filter?
Characteristics of a filter, A filter has the following characteristics: Attenuation = 3.0 dB from 0 Hz to 2 kHz. From 2 kHz to 20 kHz attenuation increases from 3 dB to 23 dB in a straight line when plotted on axes of power in decibels (vertical a..
A three-phase overhead transmission line has a per-phase resistance of 0.15 ohm/km, and a per-phase inductance of 1.3263 mH/km.
The aim of this experiment is to develop a bipolar transistor amplifier with a voltage gain of minus 25. The amplifier must accept input signals from a source impedance of 1 kW and provide an undistorted output amplitude of 5 V when driving a 560..
A standard silicon NPN BJT is to be used as an amplifier. The emitter voltage is biased at 4 volts, the base is biased at 5 volts, and the collector is biased at 10 volts. Will this circuit perform as desired? Why or why not.
electronic technology in relationship to the use of personnel and access control, surveillance, and identification of authorized personnel.
This document is shown a paper on Orthogonal frequency-division multiplexing with advantages, disadvantages and uses.
How many voice channels are carried by a E1 transmission given 8 kHz sampling and 8 bit words? Why is an end of frame marker always required in a digital telephony system?
Calculate in polar form the sequence components of unbalanced lineto-neutral voltages and calculate in polar form the phase currents corresponding to the sequence components
How a transformer works and apply those rules to a transformer where the primary core cross-sectional area is twice.
What is the maximum symbol rate that the twisted pair line can carry without ISI? 256-QAM modulation is used on the link. How many bits are conveyed by each symbol?
Use a chain of flip-flop to implement a shifter register
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd