Etermine the force applied by the ram

Assignment Help Mechanical Engineering

Reference no: EM13705932

A cube of 2" dimensions is placed in a square hole (also of 2" dimensions) that is 1.998" deep. The hole was cut out of a rigid material. (The top of the cube protrudes .002" above the surface). If a flat rigid plate is placed on top of the cube and a hydraulic ram presses the plate down flush with the top of the hole, determine the stress in the x, y and z directions. Also determine the force applied by the ram. Take E=30,000 ksi and ? =0 (nu).

Reference no: EM13705932

Questions Cloud

Determine the final temperature : A closed, rigid tank is filled with a gas modeled as an idea gas, initially at 27 degrees C and a gage pressure of 300 kPa. The gas is heated, and the gage pressure at the final state is 367 kPa. Determine the final temperature, in C. The local atmos..

Center of masses of the upper arm and the forearm acts : Assume that the center of masses of the upper arm and the forearm acts in the geometric center of the respective body segment, and the center of mass of the hand acts at the same location that the cable is in the hand (given below). If the person is ..

Circle item which is intensive properties : Please circle item(s) which is (are) intensive properties: Please circle the item(s) which can be considered as pure substance in Thermodynamics: Please circle the valid statement(s) about superheated vapor with temperature T and pressure P:

Piston-cylinder assembly undergoes a thermodynamic cycle : A gas within a piston-cylinder assembly undergoes a thermodynamic cycle consisting of three processes: There are no significant changes in kinetic or potential energy.

Etermine the force applied by the ram : A cube of 2" dimensions is placed in a square hole (also of 2" dimensions) that is 1.998" deep. The hole was cut out of a rigid material. (The top of the cube protrudes .002" above the surface). If a flat rigid plate is placed on top of the cube and ..

Calculate the overall heat-transfer coefficient : The outside wall of a refrigerated storage room is 10m long and 3m high and is constructed with 100-mm concrete blocks ( k=0.935W/m C) and 10 cm of fiber insulation board (k=0.048W/m

Metal cannot experience any plastic deformation : A metal cylinder metal cylinder 120.0mm long and 15 mm in diameter is to have a tensile force of 15000N applied. Which of alluvium, copper, brass, nickel steel and titanium are good options if the metal cannot experience any plastic deformation?

Determine the final volume and pressure : Air is expanded in a poly tropic process from a pressure and volume of 350 kPa and 0.03 m3 until its volume is increased by 6.667 times. The poly tropic process has an exponent n = 1.5

Estimate the amount of heat transferred by a single fin : The engine of my go-cart has circular fins, 3 mm thick that are machined into the aluminium of the cylinder (k=240 W/m*K) such that the outer diameter of the cylinder itself (not including the fins) is 10 cm and the fins stick out from the cylinder b..

User Account

All Pages