Estimate the velocities the doplet will attain

Assignment Help Mechanical Engineering

Reference no: EM13714047

A spherical water droplet having a diameter of 1.3 mm is allowed to fall from rest in atmospheric air at 1 atm and 20C. Estimate the velocities the doplet will attain after a drop of 30, 60, and 300 m.

Reference no: EM13714047

Questions Cloud

Determine the total power output of the turbine : Super-heated water steam at 6 MPa and 400C enters a turbine with a velocity 50 m/s. It leaves the turbine at 70 kPa and 90% quality with a velocity of 200 m/s. The mass flow rate of steam is 20 kg/s. The rate of heat loss from turbine to surroundings..

Velocity profile of motor-oil flow in a circular pipe : To study the velocity profile of motor-oil flow in a circular pipe, it was proposed to conduct a test using water (instead of oil). The oil-conducting pipe diameter is 0.4 m and the expected average velocity is about 1.5 m/s. For the properties of th..

Vessel is divided into two compartments connected a valve : An insulated vessel is divided into two compartments connected by a valve. Initially, one compartment contains steam at 10 bar and 500ºC and the other is evacuated. The vale is opened and the steam is allowed to fill the entire volume, achieving a fi..

Determine the least area of a cross section of an ASTM : Determine the least area of a cross section of an ASTM-a36 steel bar required to support a tensile load of 100,000 lbs. the allowable unit stress is 36,000 psi. (Ans. nearest 100th of an inch squared)

Estimate the velocities the doplet will attain : A spherical water droplet having a diameter of 1.3 mm is allowed to fall from rest in atmospheric air at 1 atm and 20C. Estimate the velocities the doplet will attain after a drop of 30, 60, and 300 m.

Calculate the adiabatic flame temperature : Methane gas (CH4) at 25° C, 1 atm enters an insulated reactor operating at steady state and burns completely with x % of theoretical air entering at 25°C, 1 atm.

Second laws of thermodynamics : The data listed below are claimed for power cycles operating between hot and cold reservoirs at 1000 K and 400 K, respectively. For each case determine whether such a cycle is in keeping with the first and second laws of thermodynamics.

Determine the velocity of an airstream in a wind tunnel : The proposed design for anemometer to determine the velocity of an airstream in a wind tunnel is comprised of a thin metallic strip whose ends are supported by stiff rods serving as electrodes for a passage of current used to heat the strip.

A spherical water droplet having a diameter : A spherical water droplet having a diameter of 1.3 mm is allowed to fall from rest in atmospheric air at 1 atm and 20C. Estimate the velocities the duplet will attain after a drop of 30, 60, and 300 m.

User Account

All Pages