Estimate the total energy in the circuit

Reference no: EM13549609

An oscillating LC circuit consists of a 73.7 mH inductor and a 5.39 ?F capacitor. If the maximum charge on the capacitor is 3.74 ?C, what are

(a) the total energy in the circuit and

(b) the maximum current?

Reference no: EM13549609

Questions Cloud

Explain what is the percent of thallium-205 : Naturally occurring thallium has two isotopes, thallium-203 (202.9723442 amu) and thallium-205 (204.9744275 amu). The atomic mass of thallium is 204.38 amu. What is the percent of thallium-205

Estimate the impedance of the air conditioner : An air conditioner connected to a 120 V rms ac line is equivalent to a 12.7 ? resistance and a 1.53 ? inductive reactance in series. estimate the impedance of the air conditioner

Develop a decision support model using visual dss : Develop a decision support model using Visual DSS using the variables described above. Include comments within your Visual DSS model to explain the variables and your calculations.

Evaluate what is the current in the wire : 0.800-v potential difference is maintained across a 1.60-m lenght of tungsten wire (the resistivity of tungsten is 1x10-5 resistance cm) that has a corss-sectional area of 0.800mm2 what is the current in the wire

Estimate the total energy in the circuit : An oscillating LC circuit consists of a 73.7 mH inductor and a 5.39 ?F capacitor. If the maximum charge on the capacitor is 3.74 ?C, what are the total energy in the circuit

What is the specific heat of the unknown material : A 50-g block of an unknown material is at 530°C. It is dropped into a thermally insulated cup containing 0.07L of water at 20°C. If the temperature of the compound rises to 50°C, what is the specific heat of the unknown material?

Spinal fluid pressure can be measured using a spinal tap : Spinal fluid pressure can be measured using a spinal tap in which a needle is inserted in the patient's lower back with the patient sitting upright on an examination table. The pressure due to the weight of the spinal fluid (given that its density..

What is the gauge pressure at the bottom of the tube : A bottle of saline solution (with a specific gravity of 1.02) is attached to a 1.2 m long piece of tubing with a 1.0 cm inner diameter. If the tubing is held vertically, filled with saline, and clamped at the bottom, (

Determine the mass flow rate and exit velocity of the steam : Steam enters at 4 MPa and 400 degrees C enters a nozzle steadily with a velocity of 60 m/s, and it leaves at 2 MPa and 300 degrees C. The inlet area of the nozzle is 50 cm^2, and the heat is being lost at a rate of 75 kJ/s. Determine the mass flow ra..

User Account

All Pages