Estimate the tension in the wire

Reference no: EM13498471

A stainless steel orthodontic wire is applied to a tooth, as shown in the figure above. The wire has an unstretched length of 2.7 cm and a diameter of 0.2 mm. The wire is stretched 0.1 mm. Young's modulus for stainless steel is 1.80E+11 Pa.

1. What is the tension in the wire?

2. What is the magnitude of the force on the tooth due to the wires? Disregard the width of the tooth.

Reference no: EM13498471

Questions Cloud

What is the average induced emf in the secondary coil : A very long, straight solenoid with a cross-sectional area of 6.00 is wound with 40.0 turns of wire per centimeter, and the windings carry a current of 0.250. What is the average induced emf in the secondary coil

The possible causes of autocorrelation : What are some of the possible causes of this autocorrelation?

Explain the final temperature of the iron block : If the heat released during condensation goes only to warming the iron block, what is the final temperature (in C) of the iron block

Describe six typical control activities : Explain the audit procedures that your firm should carry out to obtain assurance about the amount of the provision if any that should be included in the company's financial statements, in connection with the ex-employee's ..

Estimate the tension in the wire : A stainless steel orthodontic wire is applied to a tooth, as shown in the figure above. The wire has an unstretched length of 2.7 cm and a diameter of 0.2 mm. What is the tension in the wire

Explain what pressure in atm does it exert : If 40.0 g of methane (CH4) is confined to 2.50 x10^3 mL at 200 degrees celsius, what pressure in atm does it exert

Explain what is the final energy and n value of the atom : A ground-state H atom absorbs a photon and makes a transition to the n = 4 energy level. It then emits a photon of energy 4.085 x 10^-19 J. What is the final energy and n value of the atom

A perfectly competitive firm has variable cost : 1.Suppose in the short run a perfectly competitive firm has variable cost = 6q2, and MC = 12q where q is the quantity of output produced. Also, the firm has fixed cost F = 6144.

Identification of the system users and stakeholder : Identification of the system users and stakeholder, including an explanation of the nature of information required by them and why they require such information.

User Account

All Pages